Loading manual…
Loading manual…
Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and…
IMPORTANT: Proper installation of your appliance prior to use is your responsibility. Be sure to read and follow the installation instructions that came with…
n Changes or modifications not expressly approved by Whirlpool Corporation could void the user’s authority to operate the equipment. n The antenna(s) used for…
General Cleaning IMPORTANT: Before cleaning, make sure all controls are off and the microwave oven is cool. Always follow label instructions on cleaning…
IMPORTANT: Before cleaning, make sure all controls are off and the microwave oven is cool. Always follow label instructions on cleaning products. Soap, water…
Tools and Parts Tools Needed n Measuring tape n Pencil n Scissors n Masking tape or thumbtacks n Drill n No. 2 Phillips screwdriver n Stud finder n No. 3…
Tools Needed n Measuring tape n Pencil n Scissors n Masking tape or thumbtacks n Drill n No. 2 Phillips screwdriver n Stud finder n No. 3 Phillips screwdriver…
Part Drawing Description Qty Where can find? A. Cardboard Plate Upper cabinet template and Wall template 1 B. Exhaust vent cover Exhaust vent cover for wall or…
Check the opening where the microwave oven will be installed. The location must provide: n Minimum
B A C A. 297/8" (76 cm) B. 105/16" (26.2 cm) C. 181/2" (46.9 cm) Exact dimensions may vary depending on type of range/cooktop below. *Upper cabinet and side…
See the “Installation Dimensions” illustration. n Minimum one 2" x 4" (5.1 x 10.2 cm) wood wall stud and minimum 3/8" (1 cm) thickness drywall or plaster/lath…
WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure…
Combination WARNING Excessive Weight Hazard Use two or more people to move and install or uninstall appliance. Failure to do so can result in back or other…
WARNING Excessive Weight Hazard Use two or more people to move and install or uninstall appliance. Failure to do so can result in back or other injury. 1. To…
This microwave oven is designed for adaptation to the following three types of ventilation, choose one type before installation. NOTE: For roof venting and…
The Microwave oven is set for recirculation installation. For wall or roof venting, changes must be made to the venting system. NOTE: Skip below sections if…
1. Using diagonal wire cutting pliers, gently snip out the rectangular vent cover on the damper plate. A. Diagonal wire cutting pliers B. Damper vent covers 2.…
1. Remove screws attaching damper plate to top of microwave oven exterior. Slide damper plate toward the front of the microwave oven and lift up. A. Screws B.…
1. Remove screws attaching B and C cover. Slide them out. Keep C for step 2 use. B B C A A. Screws B. Recirculation vent covers C. Recirculation lighting cover…
NOTE: If no wall studs exist within the cabinet opening, do not install the microwave oven. See illustrations in “Possible Wall Stud Configurations.” 1. Using…
1. Using a tape, measure clearly and mark the vertical centerline of the opening. Make sure it aligns with the vertical wall centerline. Use a pencil to draw…
The microwave oven must be installed on a minimum of 1 wall stud, preferably 2, using a minimum of 1 lag screw, preferably 2. See “Find the Wall Stud(s)”…
1. Using a drill and the 3/4" (1.9 cm) hole saw, cut out the power cord hole (A). 2. Drill two mounting nut holes (B), which are 3/8" (10 mm) holes at points…
1. Drill holes at A, B, H, & J, if the Wall studs are not located A and B hole, do not drill A and B hole, and follow the below instruction. In addition to…
1. Position mounting plate on the wall. 2. Secure the mounting plate to the wall at both end holes drilled into the wall studs and/or drywall using either…
This section is intended for architectural designer and builder/contractor reference only. NOTES: n Vent materials needed for installation are not provided…