Gigabyte FI27Q-P (AORUS FI27Q-P) user manual

Contents

1. Safety Informationp. 3

   Regulatory Notices United States of America, Federal Communications Commission Statement Supplier’s Declaration of Conformity 47 CFR § 2.1077 Compliance…

2. Regulatory Noticesp. 3

   United States of America, Federal Communications Commission Statement Supplier’s Declaration of Conformity 47 CFR § 2.1077 Compliance Information Product Name…

3. Safety Precautionsp. 9

   Read through the following Safety Precautions before using the monitor. • Only use the accessories that are provided with the monitor or that which are…

4. Introductionp. 11

   Unpacking 1. Open the upper cover of the packaging box. Then observe the unpacking label attached on the inner cover. 2. Making sure the box is in the correct…

5. Unpackingp. 11

   1. Open the upper cover of the packaging box. Then observe the unpacking label attached on the inner cover. 2. Making sure the box is in the correct…

6. Product Overviewp. 14

   Front View 1 2 1 Power LED 2 Control button

7. Getting Startedp. 16

   Installing the Monitor Base 1. Place the monitor on the lower EPS foam, with the screen facing down. 2. Align and slide the hooks of the stand into the…

8. Installing the Monitor Basep. 16

   1. Place the monitor on the lower EPS foam, with the screen facing down. 2. Align and slide the hooks of the stand into the mounting slots on the rear of the…

9. Adjusting the Viewing Anglep. 18

   Note: Hold the monitor base so that the screen does not topple when you make the adjustment. Adjusting the Tilt Angle Tilt the screen forward or backward to…

10. Installing a Wall-Mount Bracket (Optional)p. 20

    Use only the 100 x 100 mm wall mount kit recommended by the manufacturer. 1. Place the monitor on the lower EPS foam, with the screen facing down. 2. Push the…

11. Making Connectionsp. 22
12. Using the Devicep. 23

    Turning the Power On/Off Power On 1. Connect one end of the power cable to the AC IN jack at the rear of the monitor. 2. Connect other end of the the power…

13. Turning the Power On/Offp. 23

    Power On 1. Connect one end of the power cable to the AC IN jack at the rear of the monitor. 2. Connect other end of the the power cable to a power outlet. 3.…

14. Managing the Cablesp. 24

    1. Align the cable clip with the clip holes at the rear of the monitor. 2. Press the cable clip firmly until it is fully seated. Then route the connected…

15. User Comfort Recommendationsp. 24

    The following are some tips for comfortable viewing of your monitor: • Optimal viewing distances for monitors range from approximately 510 mm to 760 mm (20” to…

16. Selecting the Input Sourcep. 25

    1. Move the Control button right ( ) to enter the Input menu. 2. Move the Control button up/ down ( ) to select the desired input source. Then press the…

17. Operationsp. 26

    Quick Menu Hot Key By default, the Control button has been assigned with the specific function. Note: To change the preset hot key function, refer to the…

18. Quick Menup. 26

    Hot Key By default, the Control button has been assigned with the specific function. Note: To change the preset hot key function, refer to the “Quick Switch”…

19. Configure the Device Settingsp. 31

    When the Main menu appears on the screen, move the Control button up ( ) to enter the Settings menu. Note: Use the Control button to navigate through the menu…

20. Appendicesp. 41

    Specifications Item Specifications Panel Size 27-inch Aspect Ratio 16:9 Resolution 2560 x 1440 Refresh Rate 165Hz LED Life 30000 hours (min.) Pixel Pitch 0.233…

21. Specificationsp. 41

    Item Specifications Panel Size 27-inch Aspect Ratio 16:9 Resolution 2560 x 1440 Refresh Rate 165Hz LED Life 30000 hours (min.) Pixel Pitch 0.233 x 0.233…

22. Supported Timing Listp. 42
23. Troubleshootingp. 43

    Problem Possible Solution(s) No power • Make sure the power cable is properly connected to the power source and the monitor. • Check the cable and plug to make…

24. Basic Carep. 44

    When the screen becomes dirty, do the following to clean the screen: • Wipe the screen with your soft, lint-free cloth to remove any residual dust. • Spray or…

25. Notes on USB Chargingp. 44

    The following devices are not compatible with BC 1.2 of CDP mode. When the Hub is connected to a PC, these devices cannot be charged using the USB cable.…

26. GIGABYTE Service Informationp. 44

    More service information, please visit GIGABYTE official website: https://www.gigabyte.com/