Loading manual…
Loading manual…
General This manual introduces basic operations of the digital indoor monitor (hereinafter referred to as "VTH"). Models Non 2-wire, 7-inch VTH that supports…
This section introduces content covering the proper handling of the device, hazard prevention, and prevention of property damage. Read carefully before using…
The VTHs have the same front panel but differ in the ports in the rear panel. Some support 2-wire and others do not. Slight differences might be found in the…
Rear Panel (2-wire) 1.2 Rear panel Figure 1-2 Table 1-1 Components No. Name 1 RS-485 and power output port 2 Alarm port 3 2-wire port 4 Network port
Rear Panel (non 2-wire) 1.3 Rear panel Figure 1-3 Table 1-2 Components No. Name 1 RS-485 and power output port 2 Alarm port 3 Power input port 4 Network port
Preparations 2.1 Do not install the VTH in harsh environment with condensation, high temperature, dust, corrosive substance and direct sunlight. In case of…
This chapter provides a step-by-step configuration of the VTO. Follow the instructions below to get started. The snapshots are for reference only and slight…
Configuring VTO Number 3.3 Numbers can be used to distinguish each VTO, and we recommend you set it according to the unit or building number. You can change…
TCP/IP information Figure 3-7 Enter each parameter, and then click Save. Step 2 The VTO will automatically restart. You need to add the IP address of your PC…
The VTO will automatically restart, and then you can add other VTOs and VTHs to this VTO. If the current VTO does not work as the SIP server, do not enable SIP…
Adding VTOs 3.7 You can add VTOs to the SIP server, and all the VTOs connected to the same SIP server can make video call to each other. This section is…
Register Password Keep the default value. Build No. Available only when other servers work as the SIP server. Unit No. IP Address VTO IP address. Username VTO…
This chapter introduces the configuration of the VTH and how to achieve the intercom function. Follow the instructions below to get started. Before You Begin…
Initialize the devices Figure 4-6 Tap One-key Config to finish the configuration of the VTO and VTH, as well as the SIP server. Step 9 The status bar will…
After the basic configuration is complete, check whether the intercom function can work. VTO Calling VTH 5.1 Dial a room number on the VTO (for example, 9901).…
Cybersecurity Recommendations Appendix 1 Mandatory actions to be taken for basic device network security: 1. Use Strong Passwords Please refer to the following…