Loading manual…
Loading manual…
General This manual introduces the functions and operations of the HDCVI speed domes and PTZ cameras (hereinafter referred to as "the Device"). Safety…
The manual will help you to use the Device properly. Read the manual carefully before using the Device, and keep it well for future reference. Operating…
1.1 Introduction The Device is integrated with clear image, digitization, and intelligence. It adopts new design, and is easy to install. After installing the…
The Device is integrated with clear image, digitization, and intelligence. It adopts new design, and is easy to install. After installing the Device, the…
HD Video The image resolution is in megapixels. Transmission without Any Loss The data can be transmitted for up to 500 meters through 75-3 coaxial cable…
The Device is intended to use with matched back-end devices such as HCVR, DVR, and XVR. The manual takes using with XVR as an example. Before controlling the…
3.1 Self-test After you install and power on the Device, it will perform self-test. If the self-test is normal, device information such as address, baud rate…
After you install and power on the Device, it will perform self-test. If the self-test is normal, device information such as address, baud rate, parity, PTZ…
With the OSD menu, you can configure the functions of the Device, and complete settings. Step 1 Right-click on the live interface, and then select PTZ Control.
ERR on the menu means that there is an error about the parameter. In this case, you can restore the Device to factory default settings. • The parameters vary…
3.4.1 System Settings Open the OSD menu, move the cursor to System Setting, and then click Enter to enter the second-level menu. Figure 3-5 System settings…
4.1 Regular Cleaning To ensure clear image, you need to clean the lens glass regularly. • Handle the Device with care. Hold the dome with your hands, and avoid…
To ensure clear image, you need to clean the lens glass regularly. • Handle the Device with care. Hold the dome with your hands, and avoid touching the glass…
Table 4-1 Troubleshooting Issue Possible Reason Solution No self-test and no image after the Device is powered on. Red LED light on the power board is off. •…