Loading manual…
Loading manual…
WARNING: Read This Manual • Read and follow all
Step 1-1 Viewing the typical installation A typical installation will be similar to the one shown below. The actual units may look different from the images…
A typical installation will be similar to the one shown below. The actual units may look different from the images depicted here. Evaporator/ fancoil (indoor)…
Upon receipt, inspect the product to verify that it has not been damaged during transport. If the product appears damaged, do not install it and immediately…
Materials in the indoor unit package Make sure that the indoor unit package contains the following materials: Mounting bracket (1) **07******* **09*******…
English Installation Step 2-1 Attaching the mounting bracket to the wall 1 Hold the mounting bracket against the wall at the selected installation position…
In Step 2-2, step 3 you determined the exit position for the piping bundle. If using the right, bottom, or right rear exit, change the drain hose connection…
To promote proper condensate draining, the recommended installation of the outdoor unit is elevated above the ground on a mounting bracket attached to a…
English Installation
Pour water into the drain pan. CAUTION • Make sure that the water does not overflow onto the electrical connection. 2 Check for leaks at the drain connection…
Before inspecting the leakage, use a torque wrench to close the cap for the stop valve. (Comply with a tightening torque for each size of the diameter, and…
CAUTION • Because the system does not have filter driers, you must perform this triple evacuation procedure to remove all noncondensables and moisture from the…
The outdoor unit is charged with sufficient R-32 refrigerant to support up to a 5 m line set. For lengths greater than 5 m, you must add 15 g of refrigerant…
Performing the gas leak tests for repair In case of repair of the refrigerant circuit, the following procedure must be kept to consider flammability. 1 Remove…
(Wired remote controller, central remote controller etc.) 1 Turn the power off and take off the cover panel of the indoor unit. 1 2 2 Attach the Sub PCB to the…