Loading manual…
Loading manual…
Before you install any computer component, we recommend that you read the following sections. These sections contain important
along with pre-installation and postinstallation instructions. ESD precautions Electrostatic discharge (ESD) can damage your processor, disk drives, expansion…
Always observe the following before you install any component: 1. Make sure that the ODD and card reader slot is empty. 2. Turn off the power to the computer…
Removing the left side system cover 1. Before you proceed, make sure that you have turned off your computer and all peripherals connected to it. Read the…
1. Before you proceed, make sure that you have turned off your computer and all peripherals connected to it. Read the Pre-installation instructions on page 2.…
1. Align the cover to the sides of the computer and slide the cover toward the front of the computer (1). 2. Secure the cover with two screws (2). 3. Observe…
The computer supports installation of two 3.5- inch SATA hard drives in the internal HDD cage
1. Perform the Pre-installation instructions on page 2. 2. Disconnect the power and data cables from the hard drives. 3. Remove the hard drives from the hard…
1. Remove the new hard drive from their packaging. 2. Place the hard drive into the carrier (1) and reinsert the retaining screws into the hard drive (2). 3.…
The computer has four DDR5 U-DIMM slots that support up to 64 GB maximum system memory
To ensure data integrity, use only Acerapproved DDR5 4800 MHz type memory modules. • According to Intel’s specs, when DIMM3 or DIMM4 slots are populated, DDR5…
1. Perform the Pre-installation instructions on page 2. 2. Remove the graphics board. See Removing the graphics board on page 14. 3. Press outward the holding…
1. Select an empty DIMM slot. 2. Remove the new memory module from its packaging, handling it by the edges. 3. Align then insert the memory module into the…
The computer contains one or two Graphic boards installed in the PCIE x16 slots. The detail configuration will be differed by different models
1. Remove the new graphics board from its packaging. 2. Insert the graphics boards into the PCIE x16 slot and press it down until it latches into place. 3.…
The computer contains two M.2 SSD modules installed in the M.2 PCIE slots
1. Remove the new M.2 SSD module from its packaging. 2. Place a thermal pad into the SSD module. 3. Insert the M.2 SSD2 module into its slot in the mainboard.
Pulsar Lighting (RGB Lighting Effects) Fan Control Monitoring (System Information Dashboard) To set up the PredatorSense application (Windows 10): 1.…
Select the Pulsar Lighting tab to configure the system’s lighting options. Category Description Lighting Profile Shows the current lighting profile used by the…
Select the Fan Control tab to adjust the fan speed. Category Description Auto Allows system to control fan speed according to actual system usage. Gaming…
Select the Monitoring tab to view CPU/System and GPU performance. Category Description CPU/System Displays CPU and System temperature and loading. Also…