Loading manual…
Loading manual…
To maintain compliance with EMC regulations, use shielded signal cables to connect to the following terminals: HDMI IN, DisplayPort IN, USB Downstream Port…
— a third-party sustainability certification for IT products TCO Certified is a global sustainability certification for IT products, available for computers…
nTrademarks DisplayPort™ and the DisplayPort™ logo are trademarks owned by the Video Electronics Standards Association (VESA®) in the United States and other…
If any component should be missing, please contact your dealer. Liquid Crystal Display Monitor: 1 Cable holder: 1 Power cord Base: 1 Signal cable…
nAttaching the base 1. Place the monitor face down on a non-abrasive surface (Figure 1). 2. Please rotate the stand 90 degrees as shown in Figure 1. 3. Attach…
nFront/Rear View (2) (1) Item Function (1) LED LED Indicates that the power is on or off. (2) 5-Direction-Key Up Down Left Right CENTER/ POWER(⏻) Short press…
1. Plug the power cord into the AC input terminal. 2. Plug the power cord into a power outlet. 1 2 For power outlet Power cord (Supplied) NOTE: Please make…
1. Place the cable holder onto the stand. 2. Place the cables in the cable holder firmly and evenly. NOTE: Please check that you can still rotate, raise and…
1. Turn on the monitor by pressing the POWER key. NOTE: If you have any problems please refer to the Troubleshooting section of this OPERATION MANUAL (see…
Displaying the menu screen LEFT/RIGHT Opens the OSD menu. RIGHT: Enters sub-menus or adjustment settings in the OSD menu when the OSD menu is open. LEFT: Exits…
LEFT/RIGHT Opens the OSD menu. RIGHT: Enters sub-menus or adjustment settings in the OSD menu when the OSD menu is open. LEFT: Exits the OSD sub-menus…
Below is a brief summary of where controls are under each menu item. Luminance: Brightness and Eco Mode settings. Image Setup: Screen adjustment settings.…
Provides stable and high-speed data communication by LAN (RJ-45) connection. Example of LAN connection: Ethernet Hub LAN cable Router/Server Monitor USB-C…
No picture • Make sure the signal cable is fully connected to the monitor and the computer. • Make sure the computer’s display card is fully seated in its…
POWER Key does not respond • Unplug the power cord of the monitor from the AC outlet to turn off and reset the monitor. LED on monitor is not lit (no blue or…
The following table shows the typical factory preset signal timing for each connection type. Some display cards may not be able to support the required…
Model E224FL E244FL Product LCD MONITOR LCD component 21.45 class (Diagonal 54.48 cm / 21-7/16 inch) Active matrix: thin film transistor (TFT) liquid crystal…
When moving the monitor, be sure to hold its sides or bottom. Do not hold the LCD panel or buttons. This may cause product damage, failure, or injury. • To…
We are strongly committed to environmental protection and sees recycling as one of the company’s top priorities in trying to minimize the burden placed on the…
This monitor features an advanced energy saving capability. When a Display Power Management signal is sent to the monitor, the Energy Saving mode is activated.…
The following setting conforms to the “Normal Configuration” as defined in the “EcoDesign Regulation (2019/2021)” and is the recommended setting. • [USB…