Loading manual…
Loading manual…
General This manual introduces how to configure the villa door station (hereinafter referred to as "VTO") on the web interface. Safety Instructions The…
The following description is the correct application method of the VTO. Read the manual carefully before use, to prevent danger and property loss. Strictly…
For first-time login or after resetting the VTO, you need to initialize it on the web interface. Power on the VTO. Go to the default IP address (192.168.1.108)…
Login Before login, make sure that the PC is in the same network segment as the VTO. Go to the IP address of the VTO in the browser. For first-time login…
Main interface Table 3-1 Main interface introduction No. Function Description 1 General function : Change the password and your email address. : Go to the main…
This chapter introduces the detailed configuration of the VTO. Basic Select Local Settings > Basic. Basic Configure the parameters. Table 4-1 Basic parameter…
Parameter Description Total SD Card Capacity Displays the total and used capacity of the SD card. You can click Format to delete all the data in the SD card.…
Access Control Settings This section introduces how to configure the two locks connected to the lock port or the RS-485 port of the VTO. 4.3.1 Local Select…
System Configure time parameters, NTP server, and more. Select Local Settings > System. System Configure the parameters. Table 4-4 System parameter description…
Parameter Description to security risks and data leakage. Emergency Maintenance Enable it for fault analysis and repair. This function will occupy 8088 and…
Parameter Description security risks and data leakage. ONVIF On Allow third-party to pull video stream of the VTO through the ONVIF protocol. We recommend…
Wiegand Onvif User Add accounts for devices to monitor the VTO through the ONVIF protocol. If you delete an account, it cannot be undone. Select Local Settings…
This chapter introduces how to add, modify, and delete VTO, VTH, VTS, and IPC, and how to send messages from the SIP server to VTOs and VTHs when the VTO works…
Configure the parameters. The SIP server must be added. Table 5-1 Add VTO configuration Parameter Description No. The VTO number you configured. See Table 4-1…
Press your fingerprint on the scanner. VTS Management You can add a VTS to the SIP server, and then it can be used as the management center. It can also…
IPC Setting You can add IPC and NVR to the VTO working as the SIP server, and then all the connected VTHs can monitor them. Interfaces might vary with…
Add IPC Configure the parameters. Table 5-4 Add IPC configuration Parameter Description IPC Name Enter the name that identifies the IPC. IP Address IP address…
Log in to the web interface of the SIP server, and then select Household Setting > Status. Status Publish Information You can send messages from the SIP server…
This chapter introduces how to configure the network parameters. Basic 6.1.1 TCP/IP You can modify the IP address, subnet mask, default gateway, and DNS of the…
" for details. Create Server Certificate The unique digital identification of VTO for the SSL protocol. For first time use or after changing the IP address of…
Configure the parameters as needed. Add a UPnP service Table 6-2 Parameter description Parameter Description Service Name Enter the information as needed.…
SIP Server Select a server type as needed. The VTO you have logged in as the SIP server: Enable SIP Server, and click Save, and then the VTO will restart.…
Select Search Log. You can search for different logs, and export them to your PC as needed. If storage is full, the oldest records will be overwritten. Back up…
Cybersecurity Recommendations Cybersecurity is more than just a buzzword: it’s something that pertains to every device that is connected to the internet. IP…