Dell Pro 65 Plus P6524QT (DELL-P6524QT) service manual

Contents

1. 页 1p. 1

   Version: 01 Date: 2023/05/29 Service Manual - P6524QT

2. 页 2p. 2

   ! To ensure following safety repairing behavior, put the replaced part on the components side of PWBA, not solder side. Product Announcement: This product is…

3. 页 3p. 3

   2. Exploded view diagram with list of items 4. Select the appropriate service or support link based on your need. NOTE: 1. Go to https://www.dell.com/support.…

4. 页 4p. 4

   3. Wiring Connectivity Diagram Panel Driver board 20W speaker 20W speaker RS232 USB type C with PD 90W

5. 页 5p. 5

   4. How to connect and disconnect power cable/ connectivity cable WARNING: To change power cable/ connectivity cable, switch off power before unplugging the…

6. 页 6p. 6
7. 页 7p. 7
8. 页 8p. 8

   5. Disassembly and Assembly Procedures 5.1 Disassembly Procedures: Tool Required: - Screwdriver(Phillip head) #2 - Penknife Tool Description: List the type and…

9. 页 9p. 9

   5. Disassembly and Assembly Procedures 14pcs screws main board Use a screwdriver to remove 30pcs screws (left: 5pcs, right :5pcs, top: 10pcs, bottom: 10pcs)…

10. 页 10p. 10

    5. Disassembly and Assembly Procedures Tear off 8pcs conductive foams on the specific position of the COF of the SB, then tear off all the tape and foams, and…

11. 页 11p. 11

    5. Disassembly and Assembly Procedures Tear off 8pcs acetate tapes and 2pcs shading foam, then use a screwdriver to remove 18pcs screws for unlocking the…

12. 页 12p. 12

    5. Disassembly and Assembly Procedures Put 1pcs back bracket on the working table, then take 2pcs VESA brackets to assemble with the back bracket. Use a…

13. 页 13p. 13

    5. Disassembly and Assembly Procedures Paste 2pcs shading foams on the lest and right of the unit. Take 1pcs bottom-middle bezel to assemble with the unit…

14. 页 14p. 14

    5. Disassembly and Assembly Procedures Use a sucking tool to suck 1pcs glass and set it on a jip, then check the glass carefully and make sure no particles on…

15. 页 15p. 15

    5. Disassembly and Assembly Procedures S21 Use textured tape to fix the SB of the O/C, then turn over the unit to let the back bracket faced up. S19 Tear off…

16. 页 16p. 16

    5. Disassembly and Assembly Procedures (Torque: 2±0.3kgf) Paste 1pcs shading foam on the strip of bottom side, then assemble 1pcs key board holder with the…

17. 页 17p. 17

    5. Disassembly and Assembly Procedures Assemble 1pcs power board , 1pcs driver (FIG.1) board , 1pcs touch board and 1pcs T- (FIG.2) (FIG.3) Con board with back…

18. 页 18p. 18

    5. Disassembly and Assembly Procedures Paste 1pcs conductive tape to cover main board and USB board. Paste 2pcs white mylar tape on the specific position as…

19. 页 19p. 19

    6. Trouble Shooting Instructions Troubleshooting WARNING: Before you begin any of the procedures in this section, follow the Safety Instructions. Self-Test…

20. 页 20p. 20

    6. Trouble Shooting Instructions or Dell 65 Monitor No HDMI 3 Cable The display will go into Standby Mode in 4 minutes. www.dell.com/P6524QT P6524QT or Dell 65…

21. 页 21p. 21

    6. Trouble Shooting Instructions Built-in diagnostics Your display has a built-in diagnostic tool that helps you determine if the screen abnormality you are…

22. 页 22p. 22

    6. Trouble Shooting Instructions Common problems The following table contains general information about common display problems you might encounter and the…

23. 页 23p. 23

    6. Trouble Shooting Instructions Common Symptoms What You Experience Possible Solutions Stuck-on Pixels LCD screen has bright spots • Cycle power On-Oȸ. •…

24. 页 24p. 24
25. 页 25p. 25

    6. Trouble Shooting Instructions Speciȶc Symptoms What You Experience Possible Solutions Cannot adjust the display with touch OSD OSD does not appear on the…

26. 页 26p. 26
27. 页 27p. 27

    6. Trouble Shooting Instructions Universal Serial Bus (USB) speciȶc problems Speciȶc Symptoms What You Experience Possible Solutions USB interface is not…

28. 页 28p. 28