Loading manual…
Loading manual…
Packing contents Carefully unpack and verify that you have the items below. Some of the items may not be available depending on your region of purchase. Please…
Please turn off projector when cleaning or removing lens, or it will cause the projector shut down immediately without normal procedure. • To avoid damaging…
Specifications LU9715 Projection system DLP Single 0.67 WUXGA DMD Chip Native resolution WUXGA (1920 x 1200) Brightness 8000 Lumens Aspect ratio 16:10 Light…
Front and upper side view 1 7 6 8 3 4 5 2 1. Foot for adjusting projector level 2. IO panel 3. Control panel 4. Slide switch (voltage selection) 5. AC power…
Lens specifications Model Name Lens Type BenQ Part Number Optical spec Throw Ratio Zoom Ratio Weight* LS1ST4 Ultra Short Throw 5J.JCY37.002 F=2.0, f=5.64 mm…
Model Name Lens Type BenQ Part Number Optical spec Throw Ratio Zoom Ratio Weight* LS1ST4 Ultra Short Throw 5J.JCY37.002 F=2.0, f=5.64 mm 0.38:1 Fixed 2,710g…
Distance (A) Height (B) Lens center SCREEN LU9715 Screen Size 5J.JAM37.011 5J.JAM37.021 5J.JAM37.001 5J.JAM37.051 Wide Fix Lens Wide Zoom Lens STD Lens Semi…
adjustable range The adjustable range for lens shift is tabulated below and subject to the conditions listed. Model Name Lens Type BenQ Part Number Lens Shift…
Ceiling mount installation Screen Top H C X 0.1H Shift Range Screen Center Desktop installation C H 0.1H Shift Range Screen Center Note: • Lens Shift function…
illustration Air inlet Air inlet Air outlet
Air inlet Air inlet Air outlet
For proper ventilation of the projector, make sure to leave some space around the projector as shown in the illustration below: 11.8 in / 30 cm or greater 11.8…
Interlock switch Do not remove the top cover. Otherwise, the projector will be powered off. Do not remove the projection lens. Otherwise, the projector will be…
Do not remove the top cover. Otherwise, the projector will be powered off. Do not remove the projection lens. Otherwise, the projector will be powered off
Please make sure the Voltage Switch is selected at the right voltage in the region where projector is being used. Note: Default setting is 230V.
There are four adjuster feet on the bottom of the projector, these can be used if it is necessary to change the projection angle. Screw the feet in or out as…
Indicator messages Several indicator messages are used by the projector to alert users about problems with setup or system error. The LEDs on top cover of the…