QNAP TS-831XU-RP (TS-831XU-RP-4G) user manual

Contents

1. Safety Warningsp. 10

   1. The NAS can operate normally in the temperature range of 0ºC–40ºC (or up to 35ºC depending on individual product specifications) with a relative humidity of…

2. Chapter 1. CPU and Memory Specificationsp. 11

   Caution: Modifying the hardware, software, or firmware of the QNAP products will void the warranty. QNAP is not responsible for any form of damage or loss of…

3. Chapter 2. Power Button and Reset Button Behaviorp. 39

    Power button: Press to turn on or turn off. System Power button (Turn on) Power button (Hardware turn off) Power button (Force turn off) All models Press…

4. Chapter 3. USB One Touch Copyp. 40

   System Number of seconds (press the one touch copy button to trigger data copy) All NAS models 0.5 sec Data Copy by the Front USB Port The NAS supports instant…

5. Chapter 4. LED and Alarm Buzzer Specificationsp. 41

   The LED indicators of the NAS indicate the system status and information. When the NAS is turned on, check the following items to make sure the system status…

6. Chapter 5. Upgrade Memory on QNAP Turbo NAS (RAM Module Installation)p. 44

   Warning:  The following instructions should only be performed by an authorized and trained technician.  Strictly adhere to the instructions to install a RAM…

7. Chapter 6. Network Expansion Card Installationp. 63
8. Chapter 7. Install and Hot-swap Hard Drivesp. 81

   Caution:  Before starting, please ensure that you turn off the NAS, disconnect the power adaptor, network cable(s), and also remove any other device/cable…

9. Chapter 8. Install M.2 SSDsp. 103

   8.1 M.2 SSD Heat Sink Installation NAS models that support M.2 SSDs are packaged with M.2 SSD heat sinks. For reliable operation, it is recommended that you…

10. Chapter 9. RAID Recoveryp. 109

    The QNAP NAS supports RAID recovery when a healthy drive is unexpectedly removed from a RAID or JBOD configuration. Even if a healthy drive is removed from a…

11. Chapter 10. Use the LCD Panelp. 111

    This feature is only available for NAS models with LCD panels. LCD Panel – QTS 4.3.0 and above You can use the LCD panel to configure system settings and view…

12. Chapter 11. Install Power Supply Unitp. 117

    Note: This section applies to rackmount NAS models only. The power supply units of TS-879U-RP and TS-EC879U-RP should only be replaced by an authorized and…

13. Technical Supportp. 121

    QNAP provides dedicated online support and customer service via instant messenger. Online Support: http://qnap.com/support Forum: http://forum.qnap.com…

14. GNU GENERAL PUBLIC LICENSEp. 122

    Version 3, 29 June 2007 Copyright © 2007 Free Software Foundation, Inc. <http://fsf.org/> Everyone is permitted to copy and distribute verbatim copies of this…

15. Appendix A: Product Compliance Classp. 135