Loading manual…
Loading manual…
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class A digital device…
The Control Box Gen. 2 is an Ethernet-based controller device that connects and integrates a spate of devices to provide single-access configuration and…
The following is a checklist of the items to prepare / consider before you start: Go through the numbers and types of ports available, and see if it…
The installation of the Control Box Gen. 2 shall be done in the following order: Step 1 — Mounting the Control Box see Placement, page 10. Step 2 —…
Rack Mount The Control Box can be mounted onto a 19” (1U) system rack. VK2100A / VK2200 1. Using the rack mount kit, attach the 2 mounting brackets onto the…
The Control Box can be mounted onto a 19” (1U) system rack. VK2100A / VK2200 1. Using the rack mount kit, attach the 2 mounting brackets onto the sides of the…
To place the Control Box on a flat surface, such as a desk, simply attach the foot pad set provided onto its 4 corners and place it on the surface
1. Use a grounding wire to ground the unit by connecting one end to the grounding terminal (No. 9, Rear Panel, page 6) and the other end to a suitable grounded…
Setting Control Box ID For VK1200 / VK2200, use the LCD panel on the front panel to set its ID. For VK1100A / VK2100A, use the Control Box ID switch to set…
For VK1200 / VK2200, use the LCD panel on the front panel to set its ID. For VK1100A / VK2100A, use the Control Box ID switch to set its ID. Note: Take…
The network information of the VK1200 / VK2200 can be found on its LCD panel, via Information, as illustrated below. VK1100A / VK2100A VK1200 / VK2200 DHCP…
There are two methods of changing the network settings of the Control Box — via IP Installer or web interface — on a PC within the same subnet. IP Installer 1.…
The current firmware version of the Control Box is displayed on its web interface main page, as shown below. Upgrading Firmware To upgrade the Control Box’s…
A license is a software permit that a Control Box grants to a mobile device for remote control. The Control Box’s numbers of free and maximum licenses are…
To connect the Control Box to various devices, for integration and control, refer to the corresponding interface for the wiring information of each.
s — see 12 V DC Power Output, page 19. Relay — see Relay, page 21. Digital I/O — see Digital I/O, page 23. Bidirectional Serial — see Bidirectional…
The VK1200 / VK2200 provides the following isolated relays: Using Self-Supplied Power VK1100A / VK1200 / VK2100A VK2200 Number of Channels 4 8 Contact Rating…
The Control Box Gen. 2 provides the following digital input/output channels: Digital Input Dry Contact Connects to digital I/O devices with a input loop —…
The Control Box Gen. 2 provides the following RS-232/422/485 ports: RS-232 (3-Pin) Connect to devices for controlling and receiving status messages from them.…
The LAN (VK1100A / VK2100A) or Control LAN (VK1200 / VK2200) port provides an Ethernet connection for controlling up to 25 / 64 IP devices and/or remote…
Download the ATEN Configurator software — VK6000 — from the product web page, and install it on a PC
1. After installing the ATEN Configurator, the main page appears. start by clicking the Project tab at the top. 2. On the Project tab, provide the information…
For adding additional ports, users can purchase the ATEN Expansion Boxes to be connected to the Control Box for flexible scalability, including: © Copyright…