StarTech.com Desk Mount Dual Monitor Arm (ARMSLIMDUAL2USB3) user manual

Contents

1. Product Diagramp. 7
2. Front Viewp. 7
3. Product Dimensionsp. 8

   Actual product may vary from image

4. Product Rotationp. 9
5. Product Informationp. 10

   Package Contents Base Qty: 1 Lower Arm Qty: 1 Upper Arm Qty: 1 Crossbar Qty: 1

6. Technical Specificationsp. 14
7. Requirementsp. 16

   Phillips Head Screwdriver x 1 • Displays x 2 • (Optional) USB 3.0 Cables x 2 Assembling the Monitor Mount Using the C-Clamp 1. Align the Screw Holes (x 4) on…

8. Using the Grommet Mountp. 31

   1. Align the Screw Holes (x 4) on the Base Plate with the Screw Holes on the bottom of the Base.

9. Mounting the Monitorsp. 43

   1. Place the Monitor screen side down on a flat, clean surface. 2. (Optional) Remove any Screws or Place Holders from the VESA Mounting Holes on the back of…

10. Adjusting the Spring Arm Tensionp. 48

    1. Using your hand push downward on the Upper Arm holding it in place. 2. Using the 6 mm Hex Key, rotate the Adjustment Screw located at the base of the Upper…

11. Adjusting the Rotationp. 49

    1. Using the 4 mm Hex Key, loosen the four Screws on the back of the VESA Mount. 2. Adjust the rotation of the Crossbar +40 or -40. 3. Use the 4 mm Hex Key to…

12. Making Micro-Adjustmentsp. 50

    1. While holding the Monitor in place, use a Phillips Head Screwdriver to loosen the VESA Mount Adjustment Screw on the side of the VESA Mount. 2. Using a…

13. Routing the Cablesp. 51

    1. Using a Phillips Head Screwdriver, remove the Screw from the Cable Cover, located underneath the Upper Arm and unhook the Retention Hook. 2. Slide the Cable…

14. Using the 3.0 USB Passthough Portsp. 53

    1. Plug the two USB Cables on the back of the Base into USB Ports on the Host Computer. 2. Connect a 3. 0 USB Cable to the USB Ports on the front of the Base…