Loading manual…
Hannspree HP248PJB user manual
Open PDFOpens the file on objects.icecat.biz.
Contents
- SAFETY NOTICEp. 5
1. The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 2.…
- PRECAUTIONSp. 5
Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. • Do not place the monitor on…
- SPECIAL NOTES ON LCD MONITORSp. 6
The following symptoms are normal with LCD monitor and do not indicate a problem. • Due to the nature of the fluorescent light, the screen may flicker during…
- FEATURESp. 7
60.5cm / 23.8” Wide Screen TFT Color LCD Monitor • Crisp, Clear Display for Windows • GP Green Product • Ergonomic Design • Space Saving, Compact Case Design
- CHECKING THE CONTENTS OF THE PACKAGEp. 7
The product package should include the following items: Quick Start Guide Warranty Card EUR Energy Label Power Cord HDMI Cable Screws LCD Monitor
- INSTALLATION INSTRUCTIONSp. 8
INSTALL REMOVE Figure.1. Installing and Removing the Base INSTALLATION: 1. Align the monitor with the opening in the base. 2. Install the base on arm with 4…
- POWERp. 8
SOURCE: 1. Make sure that the power cord is the correct type required in your area. 2. This LCD monitor has an Internal universal power supply that allows…
- SETTING THE MONITOR ON THE WALLp. 9
DISSEMBLING THE STAND BASE: 1. Disconnect all the cables and cords from the Monitor to prevent breakage. 2. Carefully place the Monitor face down on a soft and…
- MAKING CONNECTIONSp. 10
CONNECTING TO A PC Turn off your computer before performing the procedure below. 1. Connect one end of the VGA cable to the back of the monitor and connect the…
- ADJUSTING THE VIEWING ANGLEp. 11
For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s angle to your own preference. • Hold the stand so you…
- GENERAL INSTRUCTIONSp. 12
Press the power button to turn the monitor on or off. The other control buttons are located on the front panel of the monitor (See Figure 4). By changing these…
- FRONT PANEL CONTROLp. 13
Power Button: Press this button to switch ON/OFF of monitor’s power. • Power Indicator: Blue — Power On mode. Blue Flicker— Power Saving mode. • MENU / ENTER…
- PLUG AND PLAYp. 16
Plug & Play DDC2B Feature This monitor is equipped with VESA DDC2B capabilities according to the VESA DDC STANDARD. It allows the monitor to inform the host…
- TECHNICAL SUPPORT (FAQ)p. 17
Q & A FOR GENERAL PROBLEMS PROBLEM & QUESTION POSSIBLE SOLUTION Power LED is not on *Check if the Power Switch is in the ON position. *Power Cord should be…
- Q & A FOR GENERAL PROBLEMSp. 17
PROBLEM & QUESTION POSSIBLE SOLUTION Power LED is not on *Check if the Power Switch is in the ON position. *Power Cord should be connected. No Plug & Play…
- ERROR MESSAGE & POSSIBLE SOLUTIONSp. 19
CABLE NOT CONNECTED: 1. Check that the signal-cable is properly connected, if the connector is loose, tighten the connector’s screws. 2. Check the…
- APPENDIXp. 21
SPECIFICATIONS LCD Panel Driving system TFT Color LCD Size 60.5cm / 23.8” Diagonal Pixel pitch 0,274mm(H) × 0,274mm(V) Video H-Frequency 30KHz – 83KHz…
- SPECIFICATIONSp. 21
LCD Panel Driving system TFT Color LCD Size 60.5cm / 23.8” Diagonal Pixel pitch 0,274mm(H) × 0,274mm(V) Video H-Frequency 30KHz – 83KHz V-Frequency 56Hz – 75Hz…