StarTech.com Desk Mount Monitor Arm (ARMPIVOTB2) user manual

Contents

1. Compliance Statementsp. 2

   Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols This manual may make reference to trademarks, registered trademarks, and other…

2. Warning Statementsp. 3

   Make sure that you assemble this product according to the instructions. • Do not exceed the weight capacity of this product. Overloading this product might…

3. Safety Statementsp. 5

   Safety Measures • Cables (including power and charging cables) should be placed and routed to avoid creating electric, tripping or safety hazards. Mesures de…

4. Product Diagramp. 7
5. Product Dimensionsp. 8
6. Product Rotationp. 9
7. Product Informationp. 10

   Specifications Type of measurement Measurement VESA mounting hole pattern 75x75 100x100 Tilt +900 to -150 Screen size Maximum 30 in. (762 mm) Rotate 3600…

8. Specificationsp. 10

   Type of measurement Measurement VESA mounting hole pattern 75x75 100x100 Tilt +900 to -150 Screen size Maximum 30 in. (762 mm) Rotate 3600 Swivel 3600…

9. Installationp. 13

   Using the Grommet Mount 1. Turn the Desk Mount over so that the Support Pole faces downwards. Use the M3 Hex Keys to remove the four Hex Screws that are…

10. Using the Grommet Mountp. 13

    1. Turn the Desk Mount over so that the Support Pole faces downwards. Use the M3 Hex Keys to remove the four Hex Screws that are holding the base of the…

11. Using the C-Clampp. 15

    By default, the Desk Mount comes with the C-Clamp preassembled. If you assembled the Grommet mount and want to switch back to a C-Clamp. Skip to step 5 if you…

12. Mounting the Monitor Armp. 18

    1. Slide the Swivel Arm onto the Support Pole, so that the Swivel Arm resting on the Cable-Management Clip.

13. Attaching a Monitor Using the VESA Mountp. 20

    1. Align the Mounting Holes (x 4) on the Monitor Mount with the mounting holes on the back of the Monitor. 2. Insert the Thumb Screws through the Monitor Mount…

14. Attaching an iMac Monitorp. 21

    1. Turn off the iMac Monitor and disconnect all cables connected to the back of the iMac Monitor. 2. Turn the iMac Monitor around so that the back is facing…

15. Attaching the Monitor Mountp. 25

    Notes: Attaching the Monitor Mount may require two people. The Monitor Mount supports up to a maximum of 30.86 lb. (14 kg). 1. While supporting the weight of…

16. Removing the Monitor Mountp. 27

    1. Slide the Thumb Clip towards the Arrow on the Monitor Mount, disengaging the locking mechanism. Sliding the Thumb Clip towards the Monitor Mount 2. While…

17. Adjusting the Monitor Tiltp. 27

    While supporting the weight of the Monitor, use the Hex Key (included) to loosen or tighten the Hex Screw on the side of the Monitor Mount, until the tension…

18. Routing the Cablesp. 28

    The Desk Mount comes with a Cable-Management System that can be use to run the monitor cables down the mounting arms. Note: Make sure that the cables are…