D-Link 24-port 10G SFP+ (DXS-1210-28S) user manual

Contents

1. 1. Introductionp. 9

   Audience The Web UI Reference Guide is intended for network administrators and other IT networking professionals responsible for managing the Switch by using…

2. 2. Web User Interface (Web UI)p. 10

   Connecting to the Web UI Logging into the Web UI Web Interface Navigation The Web UI provides access to most of the software features available on the Switch.…

3. 3. Systemp. 17

   Device Information System Information Settings Peripheral Settings Port Configuration Interface Description System Log Time and SNTP Time Range Device…

4. 4. Managementp. 33

   User Accounts Settings SNMP RMON Telnet/Web Session Timeout DHCP DHCP Auto Configuration DHCP Auto Image Settings DNS File System D-Link Discovery Protocol…

5. 5. Layer 2 Featuresp. 68

   FDB VLAN STP Loopback Detection Link Aggregation L2 Multicast Control LLDP FDB Static FDB Unicast Static FDB This window is used to display and configure the…

6. 6. Layer 3 Featuresp. 123

   ARP Gratuitous ARP IPv6 Neighbor Interface IPv4 Static/Default Route IPv4 Route Table IPv6 Static/Default Route IPv6 Route Table IP Multicast Routing Protocol…

7. 7. Quality of Service (QoS)p. 138

   Basic Settings Advanced Settings Basic Settings Port Default CoS This window is used to display and configure the port default CoS settings. To view the…

8. 8. Access Control List (ACL)p. 150

   ACL Configuration Wizard ACL Access List ACL Interface Access Group ACL Configuration Wizard This window is used to guide the user to create a new ACL access…

9. 9. Securityp. 172

   Port Security 802.1X AAA RADIUS IMPB DHCP Server Screening ARP Spoofing Prevention Network Access Authentication Safeguard Engine Trusted Host Traffic…

10. 10. OAMp. 230

    Cable Diagnostics Cable Diagnostics The cable diagnostics feature is designed primarily for administrators or customer service representatives to verify and…

11. 11. Monitoringp. 232

    Utilization Statistics Mirror Settings Device Environment Utilization Port Utilization This window is used to view the port utilization table. To view the…

12. 12. Greenp. 240

    Power Saving EEE Power Saving This window is used to display and configure the power saving settings of the Switch. To view the following window, click Green >…

13. 13. Toolbarp. 243

    Save Tools Wizard Online Help Surveillance Mode Logout Save Save Configuration This window is used to save the running configuration to the start-up…

14. 14. Surveillance Modep. 256

    Surveillance Overview Port Information IP-Camera Information NVR Information Management Time Surveillance Settings Surveillance Log Health Diagnostic Toolbar…

15. Appendix A - System Log Entriesp. 275

    The System Log entries are listed in this appendix. 802.1X Log Description Severity 1 Event Description: This log is recorded when IEEE 802.1X authentication…

16. Appendix B - Trap Entriesp. 291

    The Trap Log entries are listed in this appendix. 802.1X Trap Name Description OID 1 dDot1xExtLoggedSuccess This trap is sent when a host passed IEEE 802.1X…

17. Appendix C - RADIUS Attributes Assignmentp. 297

    The RADIUS Attributes Assignment on the Switch is used in the 802.1X module. The description that follows explains the following RADIUS Attributes Assignment…

18. Appendix D - IETF RADIUS Attributes Supportp. 298

    Remote Authentication Dial-In User Service (RADIUS) attributes carry specific authentication, authorization, information, and configuration details for the…