StarTech.com RK1233BKM user manual

Contents

1. Safety Statementsp. 3

   Safety Measures • Wiring terminations should not be made with the product and/or electric lines under power. • Product installation and/or mounting should be…

2. Warning Statementsp. 4

   Make sure that you assemble this product according to the instructions. • Do not exceed the weight capacity of this product. Overloading this product might…

3. Product Diagram (RK1233BKM)p. 10

   Cable Access Panel Back Door Side Panels (2) Levelers (4) Front Door Casters (4)

4. Product Informationp. 11

   Package Contents • Enclosed Rack Cabinet x 1 • 1U Fixed Shelf x 1 • M6 Mounting Screws x 50 • Cage Nuts x 50 • Door Keys x 2 • Side Panel Keys x 2 • 10 ft (3…

5. Requirementsp. 11

   For the latest requirements, please visit www.startech.com/ RK1833BKM Installation: The following Items required for installation are sold separately. •…

6. Unpacking the Rackp. 12

   Warnings: The Rack is heavy and you should exercise cau­ tion when you remove it from the Pallet. At least three people are required to unpack the Rack. Do not…

7. Installationp. 14

   Leveling the Rack The Rack will need to be properly level prior to the installation of any Rack Equipment to ensure stability. The surface the Rack is located…

8. Leveling the Rackp. 14

   The Rack will need to be properly level prior to the installation of any Rack Equipment to ensure stability. The surface the Rack is located must also be a…

9. Installing the Cage Nutsp. 15

   Note: When installing equipment in the Rack. Start at the bottom of the Rack with the heaviest equipment and work your way to the top. 1. Determine the U-space…

10. Removing the Front and/or Rear Doorp. 16

    Note: At least two people are required when removing or reinstalling a Rack Door. • With the door open at a 90 degree angle to the Rack Frame, lift the Door…

11. Removing the Side Panelsp. 16

    Notes: At least two people are required when removing or reinstalling the Side Panel from the Rack. You may have to unlock the Side Panel prior to removal.

12. Installing the Side Panelsp. 19
13. Grounding the Rackp. 19

    1. Insert an M6 Screw through the grounding point on the Grounding Wire (sold separately) and into the Ground Hole, located on the bottom of the Rack just…

14. Adjusting the Vertical Mounting Rails or Cable Management Railsp. 20

    The Mounting Rail Depth can be adjusted from 2.76” (70 mm) to 30.51” (775 mm). Note: Follow the steps below to adjust the depth of the Mounting Rails. 1. Each…