StarTech.com RK9WALM user manual

Contents

1. Compliance Statementsp. 2

   For the State of California WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov Use of Trademarks, Registered Trademarks, and other Protected Names…

2. Warning Statementsp. 4

   Make sure that you assemble this product according to the instructions. • Do not exceed the weight capacity of this product. Overloading this product might…

3. Product Diagramp. 10

   Actual product may vary from photos Number Description Number Description 1 Front Door 5 Cable Access Opening 2 Side Panel 6 Mounting Plate 3 Vents 7 Top Panel…

4. Product Informationp. 11

   Package Contents • Wall-Mount Enclosure x 1 • 1U Shelf x 1 • Roll of Hook-and-Loop Fastener x 1 • 12-24 Cage Nuts x 36 • 12-24 Screws x 36 • Door Keys x 2 •…

5. Requirementsp. 11

   are subject to change. For the latest requirements, please visit www.StarTech.com/RK9WALM. • Phillips™ type screwdriver • Appropriate tools and mounting…

6. Grounding the Enclosurep. 11

   Note: This product must be grounded. Do not use this prod­ uct without an earth ground connection. 1. Use an M6 screw to attach a grounding wire to the front…

7. Lock or Unlock the Front Doorp. 13

   To lock or unlock the front door of the enclosure, insert one of the provided door keys in the lock on the door and turn the key clockwise or counterclockwise

8. Remove the Side Panelsp. 13

   1. If the side panels are locked, use the provided side panel keys to unlock the panels. 2. Pull the two tabs on the side panel towards the center of the…

9. Replacing Side Panelsp. 14

   1. Place one of the side panels in the groove at the bottom of the enclosure. 2. Pull the two tabs on the side panel towards the center of the panel

10. Access your cablesp. 15

    Both the top and bottom panels of the enclosure have cable access covers that you can remove to access and manage your cables. 1. To take off a cable access…

11. Replacing the Cable Access Doorp. 16

    Place the cover over the cable access opening and use a Phillips type screwdriver to insert the screws through the cover and into the enclosure. Tighten the…

12. Reverse the front doorp. 17

    To accommodate different rack configurations, you can reverse the front door of the enclosure so that it opens to the left or right of the enclosure. The front…

13. Adjust the Depth of the Mounting Railsp. 18

    The mounting rails come pre-installed in the enclosure. The mounting rails can be adjusted independently in 3/4 inch (20 mm) increments to accommodate…

14. Use the Mounting Rail Tapped Holesp. 19

    The mounting rails come pre-installed in the enclosure but you can adjust the mounting rails so that you can use the tapped holes to install your equipment.…

15. Mounting the Enclosure to the Wallp. 21

    Notes: Remove all equipment from the enclosure before you attempt to mount the enclosure to the wall. Wall structures vary and it is important to make sure…

16. Installing Equipmentp. 22

    Notes: Do not add equipment to the enclosure until the enclosure is securely attached to the wall. When you load equipment into this product, load the heavi­…