Gigabyte B650 EAGLE AX Motherboard user manual

Contents

1. RAID Levelsp. 2

   (Note 1) Skip this step if you do not want to create RAID array on the SATA controller. (Note 2) An M.2 PCIe SSD cannot be used to set up a RAID set either…

2. 1-1 Configuring SATA Controllersp. 2

   A. Installing SATA hard drive(s) in your computer Install the hard drives/SSDs in the SATA/M.2 connectors on the motherboard. Then connect the power connectors…

3. A. Installing SATA hard drive(s) in your computerp. 2

   Install the hard drives/SSDs in the SATA/M.2 connectors on the motherboard. Then connect the power connectors from your power supply to the hard drives. RAID…

4. B. Configuring SATA controller mode in BIOS Setupp. 3

   Make sure to configure the SATA controller mode correctly in system BIOS Setup. Step: Turn on your computer and press <Delete> to enter BIOS Setup during the…

5. C. UEFI RAID Configurationp. 3

   Step 1: In BIOS Setup, go to Boot and set CSM Support to Disabled (Figure 2). Save the changes and exit BIOS Setup. Figure 2 The BIOS Setup menus described in…

6. 1-2 Installing the RAID Driver and Operating Systemp. 7

   With the correct BIOS settings, you are ready to install the operating system

7. A. Installing the Operating Systemp. 7

   As some operating systems already include RAID driver, you do not need to install separate RAID driver during the Windows installation process. After the…

8. B. Rebuilding an Arrayp. 8

   Rebuilding is the process of restoring data to a hard drive from other drives in the array. Rebuilding applies only to fault-tolerant arrays such as RAID 1 and…