Bosch SHE2ADF2N installation instructions

Type: Installation instructions
Language: French
Pages: 44
Category: Dishwashers
Models: SGZ1010UC SHE2ADF2N SHE2ADF6N SHE3ADF5N SHE3AEE5N SHE3AEM5N SHS3ADF5N SHX4AEF5N SMZPC002UC SMZSH1ABUC

Open PDFOpens the file on media3.bosch-home.com.

1 IMPORTANT SAFETY INSTRUCTIONSp. 3
Read all instructions carefully before use. These precautions will reduce the risk of electrical shock, fire and injury to persons. When using kitchen…
1.1 Safety definitionsp. 3
Here you can find explanations of the safety signal words used in this manual. WARNING This indicates that death or serious injuries may occur as a result of…
1.2 General informationp. 3
To reduce the risk of fire, electrical shock, or serious injury, observe the following. • Read and understand all instructions before using the appliance. •…
1.3 Safe Installationp. 3
Follow these safety instructions when installing the appliance. • These instructions are intended for use by qualified installers only. The dishwasher must be…
1.4 Electrical safetyp. 3
Follow these safety instructions to avoid electrical shock. • The dishwasher must be properly grounded before operating. This appliance must be connected to a…
1.5 State of California Proposition 65 Warningsp. 4
This product may contain a chemical known to the State of California, which can cause cancer or reproductive harm. Therefore, the packaging of your product may…
2 Before you beginp. 5
Before you begin Read these instructions before you begin to install your appliance
2.1 Inspect the Dishwasherp. 5
After unpacking the dishwasher and prior to installation, thoroughly inspect the dishwasher for possible freight or cosmetic damage. Report any damage…
2.2 Parts Includedp. 5
After unpacking all the parts, check for any damage in transit or missing parts. Power Cord Screw Clamp Spring Clamp Mounting Brackets Mounting Bracket wood…
2.3 Tools and Parts Neededp. 5
Gather these tools and additional parts before beginning the installation of your appliance. Tools Power drill Hole saw Measuring tape Phillips screwdriver…
2.4 Pre-install Checklistp. 6
Ensure that the following requirements are met when planning the installation of your appliance. WARNING Avoid Scalding or Electric Shock Hazard •Make sure the…
2.5 Electrical Requirementsp. 6
Ensure that the following electrical requirements are met. Dishwasher electrical rating Volts 120 Hertz 60 Amperes 12 Watts 1,440 (max) Electrical Supply The…
2.6 Cabinet Requirementsp. 6
Ensure that the cabinet space for the installation meets the required dimensions. If the dishwasher is to be installed in a corner, ensure that there is…
3 Installation Preparationp. 7
Installation Preparation After locating the proper place for your dishwasher, create an opening to allow for water, drain and electrical lines on the…
4 Installation Procedurep. 7
Installation Procedure Follow these instructions to install the dishwasher
4.1 Attach Water Inlet Hosep. 7
NOTICE: Avoid cross-threading •Cross-threading will cause leaks. Teflon tape •Do not use Teflon tape; it could cause leaks and damage floors or cabinetry. 1.…
4.2 Attach Drain Hosep. 8
1. Flip unit back upright, making sure the waterline is not pinched. 2. Facing the back of the unit, orient the drain hose toward direction of sink. IMPORTANT…
4.3 Pre-level the Dishwasherp. 8
Set the dishwasher to the correct height before it goes into the cabinet. 1. Measure the height of the cabinet opening. 2. Raise the front of the dishwasher to…
4.4 Attach Power Cordp. 9
Plug the end of the supply cord into the back of the dishwasher. ‒ Be sure to push it all the way in until fully seated. The outlet for the power supply cord…
4.5 Mounting Bracketsp. 9
Before installing the supplied mounting brackets, decide which method of securing the dishwasher into its enclosure will be used, top (wood or porous material)…
4.6 Install Dishwasher in Cabinet Spacep. 10
To avoid scratching the floor, use floor protection and caution when sliding the dishwasher into the cabinet. 1. Feed the power cord through the low hole in…
4.7 Level the Dishwasherp. 11
Now that the dishwasher is in the cabinet, check the levels again. 1. Level side to side by turning feet clockwise to raise or counter-clockwise to lower…
4.8 Secure the Dishwasherp. 11
1. Center the dishwasher in the opening. x x =
5 Dishwasher Connectionp. 12
Dishwasher Connection Follow these instructions to connect the dishwasher
5.1 Installing the Water Inlet Connectionp. 12
The hot water heater should be set to deliver approximately 120° F (49° C) water to the dishwasher. Water that is too hot can cause some detergents to lose…
5.2 Installing the Drain Connectionp. 13
The drain hose must be installed with either a high loop or an air gap. NOTICE: Proper drain hose installation •The dishwasher drain hose must be installed…
5.3 Electrical Connection and Test Cyclep. 13
1. For wall outlet connections, plug the dishwasher into the outlet. 2. Turn on power supply. 3. Make sure the water supply is on. 4. Turn the dishwasher on…
5.4 Attach the Toe Panelp. 14
1. Remove the toe panel fleece from the packaging and insert it at the base on the front of the dishwasher. 2. Tuck the top of the fleece into the base front…
6 Customer Servicep. 14
Customer Service With any warranty repair, we will make sure your appliance is repaired by an authorized service provider using genuine replacement parts. We…
6.1 Model number (E-Nr.) and production number (FD)p. 14
You can find the model number (E-Nr.) and the production number (FD) on the appliance's rating plate. The rating plate is located inside the appliance door.…

Bosch SHE2ADF2N installation instructions

Contents

Other documents for this model

Bosch SHE2ADF2N installation instructions

Contents

Other documents for this model