Motorola SAC3600-4001CR quick start guide

Contents

1. Warrantyp. 2

   For the complete Zebra hardware product warranty statement, go to: http://www.zebra.com/warranty

2. For Australia Onlyp. 2

   This warranty is given by Zebra Technologies Asia Pacific Pte. Ltd., 71 Robinson Road, #05-02/03, Singapore 068895, Singapore. Our goods come with guarantees…

3. Service Informationp. 2

   If you have a problem using the equipment, contact your facility’s Technical or Systems Support. If there is a problem with the equipment, they will contact…

4. Introductionp. 3

   The SAC3600-4001CR four slot spare battery charger charges up to four single spare batteries. The charger can sit on a desktop or mount on a wall. This…

5. Accessoriesp. 3

   Two screws (for wall mounting, if applicable, not available from Zebra). • Power supply for desk/wall mounting configuration (p/n PWRS-14000-148R)

6. Unpackingp. 3

   Carefully remove all protective material from around the equipment and inspect it for damage. If the equipment was damaged in transit, contact Zebra Support.…

7. Related Documentationp. 3

   LI3678 Quick Start Guide, p/n MN002323A0X. • LI3678 Product Reference Guide, p/n MN001740A0X. • DS3678 Quick Start Guide, p/n MN002648A0X. • DS3678 Product…

8. Charger Partsp. 4

   Four Slot Spare Battery Charger Front View Four Slot Spare Battery Charger Back View NOTE The USB port connection is only required to update firmware. It is…

9. Mounting the Chargerp. 5

   To mount the charger on a vertical (wall) surface: 1. Connect the power cable to the power port and an AC power source. Insert the power cable into the cable…

10. Inserting Batteriesp. 5

    To insert batteries in the battery charger, angle the battery with the contacts facing up and slide the contact side of the battery under the LED indicator…

11. Removing Batteriesp. 5

    To remove batteries from the charger, pull the battery out of the battery well from the top of the battery

12. To remove batteries from the charger, pull the battery out of the battery well from the top of the batteryp. 5

    Charging Batteries To insert batteries in the battery charger, angle the battery with the contacts facing up and slide the contact side of the battery under…

13. Charging Batteriesp. 5
14. LED Indicatorsp. 6

    Troubleshooting If the charger does not work after following the previous procedures: • Check the system power. • Check for loose cable connections. • Check…

15. Troubleshootingp. 6

    If the charger does not work after following the previous procedures: • Check the system power. • Check for loose cable connections. • Check that batteries are…

16. Maintenancep. 6

    Protect the charger from temperature extremes. • Do not store or use the charger in any location that is extremely dusty, damp, or wet. Use a soft cloth to…

17. Regulatory Informationp. 7

    This device is approved under Zebra Technologies Corporation. This guide applies to Model Number: SAC3600. All Zebra devices are designed to be compliant with…

18. Batteriesp. 7

    Taiwan - Recycling EPA (Environmental Protection Administration) requires dry battery producing or importing firms in accordance with Article 15 of the Waste…

19. Radio Frequency Interference Requirements - FCCp. 8

    Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are…

20. Other Countriesp. 9

    Japan (VCCI) - Voluntary Control Council for Interference Class B ITE Korea Warning Statement for Class B ITE Chile Este equipo cumple con la Resolución No 403…