Loading manual…
GE JDP39WWWW user manual
Open PDFOpens the file on images.salsify.com.
Contents
- Before You Beginp. 1
Read these instructions carefully and completely. • IMPORTANT — Save these instructions for local inspector’s use. • IMPORTANT — Observe all governing codes…
- Parts Includedp. 1
Lower Trim 2 Screws 2 Shoulder Screws (for stop device)
- Materials Neededp. 1
Junction Box Wire Nuts Strain Relief Clamp for 1/2” conduit PARTS INCLUDED Lower Trim 2 Screws 2 Shoulder Screws (for stop device)
- Tools You Will Needp. 1
1/8” Drill Bit and Electric or Hand Drill Phillips Screwdriver Nut Driver Level Tape Measure Straight Edge or Square Hand or Sabre Saw Standard Screwdriver…
- Important Safety Instructionsp. 2
ELECTRICAL REQUIREMENTS This appliance must be supplied with the proper voltage and frequency, and connected to an individual, properly grounded branch…
- For Your Safetyp. 2
WARNING: For personal safety, remove house fuse or open circuit breaker before beginning installation. Failure to do so could result in serious injury or…
- Electrical Requirementsp. 2
This appliance must be supplied with the proper voltage and frequency, and connected to an individual, properly grounded branch circuit, protected by a circuit…
- Pre-Installation Checklistp. 3
Hinge unlocked position Hinge slot Hinge arm DO NOT LIFT THE DOOR BY THE HANDLE! • Move Range Indoors In Front of Cabinet Opening • Protect the kitchen floor!…
- Pre-Installation Cutout and Required Clearancesp. 4
If cabinets are placed less than 30” min. above the range, see alternate construction. 30” ranges conform to U.L. requirements for 0” spacing from vertical…
- Prepare to Install the Rangep. 5
STANDARD INSTALLATION Wall 1/4” min. flat 23-3/16” 9/16” min. flat 9/16” min. flat 29-15/16”– 30-1/16” smooth cut 25” typically 1/4” R Flat area Countertop…
- Electrical Connectionsp. 6
WARNING: Improper connection of aluminum house wiring to copper leads can result in an electrical hazard or fire. Use only connectors designed for joining…
- 3-Conductor Branch Circuit Connectionp. 7
THREE-CONDUCTOR BRANCH CIRCUIT CONNECTION When connecting to a 3-conductor branch circuit, if local codes permit: Connect the bare oven ground conductor with…
- New Construction and 4-Conductor Branch Circuit Connectionp. 7
- Install the Rangep. 9
INSTALLING THE ANTI-TIP BRACKET The anti-tip bracket is attached to the back of the Drop-In Range. It is designed to fit under the bottom of the countertop…
- Alternate Construction Preparationp. 14
Refer to the Filler or Backguard Kit instructions for Installation details. OPTIONAL MAINTOP FILLER OR BACKGUARD KIT If counter opening extends to the wall, it…