Loading manual…
Loading manual…
I Check with your state and local public works department for plumbing and sanitation codes. You must follow these guidelines as you install the Heavy Duty…
This Heavy Duty Water Filtration System must be properly installed and located in accordance with the Installation Instructions before it is used. GNWH38F is…
Influent Challenge Reduction Average Substance Concentration Requirements Reduction Standard 42 Chlorine: Taste and Odor 2.0 mg/L ±10% ≥50% 95.5%
This system has been tested according to NSF/ANSI 42 for the reduction of the substances listed below. The concentration of the indicated substances in water…
FXHSC Filter could be used as a replacement filter. FXHSC Cartridge Operating Guidelines Minimum–Maximum Supply Water Pressure: 20–125 psi Minimum–Maximum…
You should change your filter when the water flow is noticeably reduced or at least every 3 months. Turn off water to filter. Water must be shut off from an…
Recommended shut-off valve Recommended shut-off valve Fitting Ferrule Hex nut Fitting Ferrule Hex nut 11⁄2″–2″ Typical installation Remote timer Mounting…
NOTE: Be sure to allow a minimum space of 11⁄2″–2″ under the filter for removing the sump to change the cartridge. Turn canister wrench clockwise to remove…
Select a location for the filter that is: I protected from freezing. I not exposed to direct sunlight. It is recommended that a shut-off valve be placed on…
WARNING: A copper or galvanized cold water pipe may be used to ground electrical outlets in the home. Failure to maintain this ground path may result in an…
Instructions are for installing fittings supplied with the filter system or similar fittings onto copper plumbing. If the unit is to be installed on any other…
Slip a compression nut onto each pipe. Next, slip the brass ferrule onto each pipe. 2 1 Hex Nut Brass ferrule Hex Nut Brass ferrule D
Align filter assembly with pipe ends making certain that the incoming water supply is going into the filter opening marked “IN”. It may be necessary to spread…
section before cutting the pipe. Turn off the water supply and open a nearby faucet to drain the water out of pipes. Using a tape measure or ruler, measure the…
Install filter, if not already done (see Filter Cartridge Replacement Section). Slowly turn on water supply. Check entire system for leaks. If leaking from…
Timer cap Timer seat Timer battery installation and change Insert coin or screw driver in the slot between timer cap and base. Gently pry them open and…
… Problem Possible Causes What To Do Water contains tiny New filter cartridges contain • Turn on a water faucet and allow these harmless carbon particles to…
For The Period Of: GE Will Replace: One Year Any part of the Water Filtration System (excluding filters) which fails due to a defect in materials in From the…
GE Appliances Website In the U.S.: www.GEAppliances.com Have a question or need assistance with your appliance? Try the GE Appliances Website 24 hours a day…