GE JVM2052SNSS user manual

Contents

1. General informationp. 2
2. Important Safety Instructionsp. 3

   ELECTRICAL REQUIREMENTS Product rating is 120 volts AC, 60 Hertz, 14 amps and 1.70 kilowatts. This product must be connected to a supply circuit of the proper…

3. Electrical Requirementsp. 3

   noted (under ELECTRICAL REQUIREMENTS), a qualified electrician should be employed to correct any deficiencies. WARNING: Risk of Electric Shock. Can cause…

4. Hood Exhaustp. 4

   The following chart describes an example of one possible ductwork installation. NOTE: Read these next two pages only if you plan to vent your exhaust to the…

5. Damage – Shipment/Installationp. 6

   PART QUANTITY Upper Cabinet 1 Template Rear Wall 1 Template (3 pieces mounting plate only) Installation 1 Instructions Exhaust 1 Adapter Damper 1 Power Cord 1…

6. Parts Includedp. 6

   ADDITIONAL PARTS Installation Instructions PARTS INCLUDED You will find the installation hardware contained in a packet with the unit. Check to make sure you…

7. Tools You Will Needp. 7

   Phillips screwdriver Flat blade screwdriver Pencil Ruler or tape measure and straight edge Carpenter square (optional) Tin snips (for cutting damper, if…

8. Mounting Spacep. 7

   NOTES: • The space between the cabinets must be 30" wide and free of obstructions. • If the space between the cabinets is greater than 30", a Filler Panel Kit…

9. Step-by-step installation guidep. 2
10. Placement of Mounting Platep. 8

    Installation Instructions Find the studs, using one of the following methods: A. Stud finder – a magnetic device which locates nails. OR B. Use a hammer to tap…

11. Installation Typesp. 11

    (Choose A, B or C) This microwave oven is designed for adaptation to the following three types of ventilation: A. Outside Top Exhaust (Vertical Duct) B.…

12. Before You Use Your Microwave Ovenp. 23

    Ensure proper ground exists before use Install turntable and ring in cavity. 3 4 5

Other documents for this model

• GE JVM2052SNSS user manual