Bosch Dishwasher 300 Series 18 Inch Recessed Handle (SPE53C55UC) installation instructions

Contents

1. 1 IMPORTANT SAFETY INSTRUCTIONSp. 3

   Read all instructions carefully before use. These precautions will reduce the risk of electrical shock, fire and injury to persons. When using kitchen…

2. 1.1 Safety definitionsp. 3

   Here you can find explanations of the safety signal words used in this manual. WARNING This indicates that death or serious injuries may occur as a result of…

3. 1.2 General informationp. 3

   To reduce the risk of fire, electrical shock, or serious injury, observe the following. • This appliance is provided with installation instructions and this…

4. 1.3 Safe Installationp. 3

   Follow these safety instructions when installing the appliance. • These instructions are intended for use by qualified installers only. The dishwasher must be…

5. 1.4 Electrical safetyp. 3

   Follow these safety instructions to avoid electrical shock. • The dishwasher must be properly grounded before operating. This appliance must be connected to a…

6. 1.5 State of California Proposition 65 Warningsp. 4

   This product may contain a chemical known to the State of California, which can cause cancer or reproductive harm. Therefore, the packaging of your product may…

7. 2 Before you beginp. 5

   Before you begin Read these instructions before you begin to install your appliance

8. 2.1 Inspect the Dishwasherp. 5

   After unpacking the dishwasher and prior to installation, thoroughly inspect the dishwasher for possible freight or cosmetic damage. Report any damage…

9. 2.2 Parts Includedp. 5

   After unpacking all the parts, check for any damage in transit or missing parts. Power Cord Screw Clamp 9/16" 15mm Mounting Brackets Mounting Bracket wood…

10. 2.3 Tools and Parts Neededp. 5

    Gather these tools and additional parts before beginning the installation of your appliance. Tools Power drill Measuring tape Crosshead screwdriver Flat…

11. 2.4 Pre-install Checklistp. 6

    Ensure that the following requirements are met when planning the installation of your appliance. WARNING Avoid Scalding or Electric Shock Hazard •Make sure the…

12. 2.5 Electrical Requirementsp. 6

    Ensure that the following electrical requirements are met. Dishwasher electrical rating Volts 120 Hertz 60 Amperes 12 Watts 1,440 (max) Electrical Supply The…

13. 2.6 Cabinet Requirementsp. 6

    Ensure that the cabinet space for the installation meets the required dimensions.

14. 3 Installation Preparationp. 7

    Installation Preparation After locating the proper place for your dishwasher, create an opening to allow for water, drain and electrical lines on the…

15. 4 Installation Procedurep. 7

    Installation Procedure Follow these instructions to install the dishwasher

16. 4.1 Pre-level the Dishwasherp. 7

    Set the dishwasher to the correct height before it goes into the cabinet. 1. Measure the height of the cabinet opening. 2. Raise the front of the dishwasher to…

17. 4.2 Attach Power Cordp. 8

    Plug the end of the supply cord into the back of the dishwasher. ‒ Be sure to push it all the way in until fully seated. The outlet for the power supply cord…

18. 4.3 Mounting Bracketsp. 8

    Before installing the supplied mounting brackets, decide which method of securing the dishwasher into its enclosure will be used, top (wood or porous material)…

19. 4.4 Install Dishwasher in Cabinet Spacep. 9

    To avoid scratching the floor, use floor protection and caution when sliding the dishwasher into the cabinet. NOTICE: Avoid Hose Kinks •Be careful while…

20. 4.5 Level the Dishwasherp. 10

    Now that the dishwasher is in the cabinet, check the levels again. 1. Level side to side by turning feet clockwise to raise or counter-clockwise to lower…

21. 4.6 Outer Door Assemblyp. 10

    •Follow the instructions for outer door assembly on the fully integrated template. Note: The door panel should weigh between 9 and 18 lbs, be at least 3/4"…

22. 4.7 Secure the Dishwasherp. 11

    1. Open the door carefully. Hold the dishwasher in place with one hand while opening the door with the other hand. 2. For top mount, drive the mounting screws…

23. 4.8 Attach the 2-part Toe Panelp. 11

    1. If your dishwasher has a rubber apron, install the 2-part toe panel behind the apron. 2. Place the slotted toe panel on the dishwasher. ‒ It should rest on…

24. 5 Dishwasher Connectionp. 12

    Dishwasher Connection Follow these instructions to connect the dishwasher

25. 5.1 Installing the Water Inlet Connectionp. 12

    The hot water heater should be set to deliver approximately 120 °F (49 °C) [max. 140 °F/ (60 °C)] water to the dishwasher. Water that is too hot can cause some…

26. 5.2 Installing the Drain Connectionp. 12

    The drain hose must be installed with either a high loop or an air gap. NOTICE: Proper drain hose installation •The dishwasher drain hose must be installed…

27. 5.3 Electrical Connection and Test Cyclep. 13

    1. For wall outlet connections, plug the dishwasher into the outlet. 2. Turn on power supply. 3. Make sure the water supply is on. 4. Turn the dishwasher on…

28. 6 Customer Servicep. 13

    Customer Service With any warranty repair, we will make sure your appliance is repaired by an authorized service provider using genuine replacement parts. We…

29. 6.1 Model number (E-Nr.) and production number (FD)p. 13

    You can find the model number (E-Nr.) and the production number (FD) on the appliance's rating plate. The rating plate is located inside the appliance door.…

Other documents for this model

• Bosch SGE53C55UC quick start guide
• Bosch SGE53C55UC installation instructions
• Bosch SGE53C55UC user manual
• Bosch Dishwasher (SPE53C55UC) user manual
• Bosch Dishwasher (SPE53C55UC) user manual
• Bosch SPE53C55UC installation instructions
• Bosch SPE53C55UC installation instructions
• Thermador Sapphire 7 Program Dishwasher (DWHD660EFP) quick start guide