Speed Queen 7.0 Cu. Ft. Commercial Coin Slide Electric Dryer 27 Inch Wide (DV4000WE) user manual

Contents

1. Safety Informationp. 7

   Explanation of Safety Instruction Messages Precautionary statements (“DANGER,” “WARNING,” and “CAUTION”), followed by specific instructions, are found in this…

2. Explanation of Safety Instruction Messagesp. 7

   Precautionary statements (“DANGER,” “WARNING,” and “CAUTION”), followed by specific instructions, are found in this manual and on machine decals. These…

3. Important Safety Instructionsp. 7

   Save These Instructions WARNING To reduce the risk of fire, electric shock, serious injury or death to persons when using your dryer, follow these basic…

4. Dimensionsp. 9
5. Installationp. 14

   Before You Start Tools For most installations, the basic tools you will need are: DRY2586N_SVG 8 7 6 5 4 3 2 1 1. Wrench 2. 1/4 inch Driver 3. Screwdrivers 4.…

6. Before You Startp. 14

   Tools For most installations, the basic tools you will need are: DRY2586N_SVG 8 7 6 5 4 3 2 1 1. Wrench 2. 1/4 inch Driver 3. Screwdrivers 4. Level 5. Gloves…

7. Position and Level the Dryerp. 15

   1. Install dryer before washer. This allows room for attaching exhaust duct. 2. Install the four rubber feet (in accessories bag). 3. Select a location with a…

8. Connect Dryer Exhaust Systemp. 17

   WARNING To reduce the risk of fire and combustion gas accumulation the dryer MUST be exhausted to the outdoors. W604 WARNING To reduce the risk of fire and the…

9. Gas Dryers - Connect Gas Supply Pipep. 22

   WARNING To reduce the risk of gas leaks, fire or explosion: • The dryer must be connected to the type of gas as shown on nameplate located in the door recess.…

10. Electric Dryer Only - Connect Electrical Plugp. 24

    Dryer requires 120/240 Volt or 120/208 Volt, 60 Hertz, 3 or 4 wire electrical supply. Refer to serial plate for specific electrical requirements. IMPORTANT…

11. Reverse Door, if Desiredp. 29

    NOTE: Doors with windows cannot be reversed. Installation © Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT 29 Part No. D516119ENR5

12. Wipe Out Inside of Dryerp. 31

    Before using dryer for the first time, use an all-purpose cleaner, or a detergent and water solution, and a damp cloth to remove shipping dust from inside…

13. Plug In the Dryerp. 31

    This appliance is to be supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30 mA. WARNING The appliance…

14. Recheck Stepsp. 32

    Refer to Installer Checklist on the back cover of this manual and make sure that dryer is installed correctly. After installation is complete, run the dryer…

15. Check Heat Sourcep. 32
16. Vendingp. 33

    Meter Case The factory mounted coin meter case does not include the service door lock, coin slide (if applicable), coin drawer, coin drawer lock or keys. These…

17. Operationp. 42

    Instructions for Nonmetered and Coin Slide Dryers WARNING To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUC-…

18. Operation Instructions for Nonmetered and Coin Slide Dryersp. 42

    WARNING To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUC- TIONS before operating this appliance. W727…

19. Operation Instructions for MDC Dryersp. 43
20. Maintenancep. 46

    Lubrication All moving parts are sealed in a permanent supply of lubricant or are equipped with oilless bearings. Additional lubrication will not be necessary

21. Lubricationp. 46

    All moving parts are sealed in a permanent supply of lubricant or are equipped with oilless bearings. Additional lubrication will not be necessary

22. Care of Your Dryerp. 46

    WARNING To reduce the risk of an electric shock, serious injury or death, disconnect the electrical service to the dryer before cleaning the interior. W132…

23. Lint Filterp. 46

    CLEAN THE LINT FILTER BEFORE DRYING EACH LOAD. (Refer to Figure 54 for lint filter location.) Cleaning the lint filter is important because a layer or pad of…

24. Motor Overload Protectorp. 47

    The dryer’s motor overload protector stops the motor automatically in the event of an overload. After cooling, the overload protector will reset itself. Dryer…

25. For Energy Conservationp. 47

    Make sure the lint filter is always clean. • Do not overload dryer. • Do not overdry clothes. • Remove items to be ironed while still damp. • Large loads of…

26. Troubleshootingp. 48

    Try these troubleshooting tips before making a service call. They may save you time and money. Dryer Symptom Possible Cause/Solution Dryer won’t start •…

27. Contact Informationp. 50

    If service is required, contact the nearest Factory Authorized Service Center. If you are unable to locate an authorized service center or are unsatisfied with…

28. Installer Checklistp. 51

    Fast Track for Installing the Dryer 1 Position and Level the Dryer. DRY2634N_SVG 6 Wipe Out Inside of Dryer. CHECK CHECK 2 Connect Dryer Exhaust System.…