APC Classic Battery Cabinet (GVSCBC10B2) user manual

Contents

1. Important Safety Instructions — SAVE THESE INSTRUCTIONSp. 5

   Classic Battery Cabinet Important Safety Instructions — SAVE THESE INSTRUCTIONS Read these instructions carefully and look at the equipment to become familiar…

2. Safety Precautionsp. 6

   DANGER HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH Read all instructions in the installation manual before installing or working on this product. Failure…

3. Specificationsp. 11

   Classic Battery Cabinet Specifications NOTICE HAZARD OF EQUIPMENT DAMAGE Refer to the UPS installation manual for detailed specifications for the UPS system.…

4. Classic Battery Cabinet Specificationsp. 11

   NOTICE HAZARD OF EQUIPMENT DAMAGE Refer to the UPS installation manual for detailed specifications for the UPS system. Failure to follow these instructions can…

5. Trip Settingsp. 12

   must be controlled during installation. Set the trip settings according to the relevant table below. GVSCBC7A UPS rating 20 kW 30 kW 40-50 kW 60 kW Power…

6. Recommended Cable Sizesp. 14

   DANGER HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH All wiring must comply with all applicable national and/or electrical codes. The maximum allowable…

7. Torque Specificationsp. 16
8. Environmentp. 16

   Operating Storage Temperature 0 °C to 40 °C -15 °C to 40 °C Relative humidity 0-95% non-condensing 10-80% non-condensing Elevation 0-1000 m Protection class…

9. Clearancep. 16

   NOTE: Clearance dimensions are published for airflow and service access only. Consult with the local safety codes and standards for additional requirements in…

10. Classic Battery Cabinet Weights and Dimensionsp. 17
11. Installation Procedurep. 18

    NOTE: The distance between the battery bank and the UPS must not exceed 200 m. Contact Schneider Electric for installations with a longer distance. 1. Unpack…

12. Receivingp. 19

    Classic Battery Cabinet Receiving External Inspection When the shipment arrives, inspect the shipping material for any signs of damage or mishandling. Check…

13. Unpack the Cabinetp. 19

    1. Remove the indicated bolts. 2. Lift up the cabinet with a forklift and remove the pallet parts. 3. Lower the cabinet to the floor and remove the indicated…

14. Prepare for Cablesp. 21

    Classic Battery Cabinet Prepare for Cables 1. Open the door(s). On GVSCBC10A2 and GVSCBC10B2, remove two screws to open the left door. 2. Lockout/Tagout the…

15. Connect the Signal Cablesp. 22

    NOTE: Route the signal cables separately from the power cables to ensure sufficient isolation. NOTE: Use double isolated signal cables. The signal cables must…

16. Connect the Power Cablesp. 25

    Classic Battery Cabinet Connect the Power Cables DANGER HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH Perform a total power off of the UPS before…

17. Add Translated Safety Labels to Your Productp. 28

    The safety labels on your product are in English and French. Sheets with translated safety labels are provided with your product. 1. Find the sheets with…

18. Final Installationp. 29

    Classic Battery Cabinet Final Installation 1. Install the provided kick plates on the front, rear, and sides of the classic battery cabinet. 990-5913B-001 29