APC Smart-UPS (SMT1000I-6W) user manual

Contents

1. Overviewp. 3

   Product Description The APC™ by Schneider Electric Smart-UPS™ is a high performance uninterruptible power supply (UPS). The UPS provides protection for…

2. Product Descriptionp. 3

   The APC™ by Schneider Electric Smart-UPS™ is a high performance uninterruptible power supply (UPS). The UPS provides protection for electronic equipment from…

3. Important Safety Messagesp. 3

   Read the instructions carefully to become familiar with the equipment before trying to install, operate, service or maintain it. The following special messages…

4. Safety and General Informationp. 3

   Inspect the package contents upon receipt. Notify the carrier and dealer if there is any damage. Read the Safety Guide supplied with this unit before…

5. Specificationsp. 4

   For additional specifications, refer to the APC by Schneider Electric Web site at www.apc.com. Environmental Temperature Operating 0° to 40° C (32° to 104° F)…

6. Product Overviewp. 5

   Front panel features Rear panel features 500 VA to 1500 VA models 1 Display interface 500/750/1000/1500 VA 2200/3000 VA 2 Bezel 3 Battery 4 Internal battery…

7. Rear panel features 2200 VA and 3000 VA models Installationp. 6

   For UPS installation information, refer to the Smart-UPS Installation Guide 750/1000/1500/2200/3000 VA 100/120/ 230 Vac, 500 VA 100 Vac Tower, that is included…

8. Operationp. 7

   Connect Equipment Note: The 2200/3000 VA 100 Vac model UPS will charge to 90% capacity in the first four and a half hours of normal operation. All other models…

9. Connect Equipmentp. 7

   Note: The 2200/3000 VA 100 Vac model UPS will charge to 90% capacity in the first four and a half hours of normal operation. All other models will charge to…

10. Display Panelp. 8

    Using the display interface Use the UP/DOWN arrow buttons to scroll through the main menu options. Press ENTER to view the submenus under each main menu…

11. Configurationp. 10

    UPS Settings Start up Settings Configure these settings at initial start up, using the display interface. As an alternative, configuration can be performed…

12. UPS Settingsp. 10

    Start up Settings Configure these settings at initial start up, using the display interface. As an alternative, configuration can be performed using…

13. Main Outlet Group and Controlled Outlet Groupp. 12

    Overview The Main Outlet Group and the Controlled Outlet Group can be configured to independently turn off, turn on, shut down, and reboot connected equipment.…

14. Emergency Power Offp. 14

    Overview The Emergency Power Off (EPO) option, is a safety feature that will immediately disconnect all connected equipment from utility power. The UPS will…

15. Troubleshootingp. 15

    Problem and Possible Cause Solution The UPS will not turn on or there is no output The unit has not been turned on. Press the ON key once to turn on the UPS.…

16. Servicep. 16

    If the unit requires service, do not return it to the dealer. Follow these steps: 1. Review the Troubleshooting section of the manual to eliminate common…

17. Two Year Limited Factory Warrantyp. 17

    Schneider Electric IT Corporation (SEIT), warrants its products to be free from defects in materials and workmanship for a period of three (3) years excluding…