APC SRT001 installation instructions

Contents

1. Installation Guide Smart-UPS™On-Line SRT001/SRT004/SRT005/SRT008p. 1

   Important Safety Information Read the instructions carefully to become familiar with the equipment before trying to install, operate, service or maintain it.…

2. Important Safety Informationp. 1

   Read the instructions carefully to become familiar with the equipment before trying to install, operate, service or maintain it. The following special messages…

3. Safety and General Informationp. 1

   Inspect the package contents upon receipt. Notify the carrier and dealer if there is any damage. Adhere to all local and national electrical codes. Recycle the…

4. Inspect the package contents upon receipt. Notify the carrier and dealer if there is any damagep. 1

   Adhere to all local and national electrical codes. Recycle the packaging

5. Deenergizing safetyp. 1

   The UPS contains internal batteries and may present a shock hazard even when disconnected from the branch circuit (mains). Before installing or servicing the…

6. Hardwire safetyp. 2

   Verify that all branch circuit (mains) and low voltage (control) circuits are deenergized, and locked out before installing cables or making connections…

7. Remove Standard PDUp. 3

   UPS models SRT5K/SRT6K Disconnect equipment connected to the UPS. 1. Press the POWER ON/OFF button located on the front of the UPS. Select Turn Off Immediately…

8. UPS models SRT5K/SRT6Kp. 3

   Disconnect equipment connected to the UPS. 1. Press the POWER ON/OFF button located on the front of the UPS. Select Turn Off Immediately to turn the UPS output…

9. PDU with 4 pin connector in SRT5K/SRT6K modelsp. 3

   Remove the ground screw and the standard PDU. Remove the connector clip and disconnect the 4 pin connector. CAUTION DAMAGE TO EQUIPMENT OR PERSONNEL • Adhere…

10. PDU with 2 pin connector in SRT5KRMXLW-HW modelp. 4
11. Install PDUp. 4

    PDU models SRT004/SRT005 SRT004 Note: Secure the 2 pin connector from the PDU to the appropriate connector on the UPS. Ignore any additional connectors on the…

12. PDU models SRT004/SRT005p. 4

    SRT004 Note: Secure the 2 pin connector from the PDU to the appropriate connector on the UPS. Ignore any additional connectors on the UPS. Connect the ground…

13. Install Output Hardwire Kitp. 6

    Model SRT001 Note: Secure the 2 pin connector on the PDU to the appropriate connector on the UPS. Ignore any additional connectors on the UPS. Connect the…

14. Model SRT001p. 6

    Note: Secure the 2 pin connector on the PDU to the appropriate connector on the UPS. Ignore any additional connectors on the UPS. Connect the ground cable to…

15. Replace Standard PDUp. 8
16. UPS models SRT8K/SRT10Kp. 8
17. Configure UPS for PDU Panelp. 10

    Reconfigure the UPS, using the display interface, to work with the new PDU. 1. Reconnect internal RBC. 2. Reconnect the XLBP if installed. 3. Reconnect the UPS…