APC Low Voltage (SMX2000LV) user manual

Contents

1. Overviewp. 3

   Product Description The APC™ by Schneider Electric Smart-UPS™ is a high performance uninterruptible power supply (UPS). The UPS provides protection for…

2. Product Descriptionp. 3

   The APC™ by Schneider Electric Smart-UPS™ is a high performance uninterruptible power supply (UPS). The UPS provides protection for electronic equipment from…

3. Important Safety Messagesp. 3

   Read the instructions carefully to become familiar with the equipment before trying to install, operate, service or maintain it. The following special messages…

4. Safety and General Informationp. 3

   Inspect the package contents upon receipt. Notify the carrier and dealer if there is any damage. Read the Safety Guide supplied with this unit before…

5. Specificationsp. 4

   For additional specifications, refer to the APC by Schneider Electric web site at www.apc.com. Temperature Operating 0° to 40° C (32° to 104° F) Storage -15°…

6. Product Overviewp. 5

   Front panel features Rear panel features Display interface panel UPS battery cable and connector Battery compartment Bezels SMX2000, 120 Vac SMX3000, 120…

7. Installationp. 6

   UPS For UPS installation instructions, refer to the Smart-UPS X 2000-3000 VA Installation Guide that is supplied with the UPS. The guide is also available on…

8. Operationp. 7

   Connect Equipment Note: The UPS will charge to 90% capacity in the first three hours of normal operation. Do not expect full battery runtime capability during…

9. Connect Equipmentp. 7

   Note: The UPS will charge to 90% capacity in the first three hours of normal operation. Do not expect full battery runtime capability during this initial…

10. Display Interfacep. 8

    operation Use the UP/DOWN arrow buttons to scroll through the main menu options. Press ENTER to view the sub menus under each main menu option. Press ESCAPE to…

11. Configurationp. 11

    UPS Settings Start up Settings Use the display interface to configure these settings at initial start up. The UPS will prompt for a response to each setting…

12. UPS Settingsp. 11

    Start up Settings Use the display interface to configure these settings at initial start up. The UPS will prompt for a response to each setting, if no response…

13. Switched Outlet Groupsp. 14

    Note: Switched Outlet Groups provide battery backup power to connected equipment. Overview The Switched Outlet Groups can be configured to independently turn…

14. Emergency Power Offp. 16

    Overview The Emergency Power Off (EPO) option is a safety feature that will immediately disconnect all connected equipment from AC power. The UPS will…

15. Troubleshootingp. 17

    Problem and Possible Cause Solution The UPS will not turn on or there is no output The unit has not been turned on. Press the ON button once to turn on the…

16. Service and Transportp. 19

    If the unit requires service, do not return it to the dealer. Follow these steps: 1. Review the Troubleshooting section of the manual to eliminate common…

17. Limited Factory Warrantyp. 20

    Schneider Electric IT Corporation (SEIT), warrants its products to be free from defects in materials and workmanship for a period of two (2) years from the…

Other documents for this model

• APC Smart-UPS X SMX2200HVNC user manual