LG 32WFC-N user manual

Contents

1. SAFETY PRECAUTIONp. 3

   Please read these safety precautions carefully before using the product. WARNING If you ignore the warning message, you may be seriously injured or there is a…

2. Precautions In Installing the Productp. 3

   WARNING • Keep away from heat sources like electrical heaters. -- Electrical shock, fire, malfunction, or deformation may occur. • Keep the packing…

3. Precautions to the AC Adapter and Electrical Powerp. 5

   WARNING • If water or any foreign substance goes inside the product (TV, monitor, power cord, or AC adapter), disconnect the power cord immediately and contact…

4. Precautions In Moving the Productp. 7

   WARNING • Make sure to turn off the product. -- You may be electrocuted or the product can be damaged. • Make sure to remove all cables before moving the…

5. Precautions In Using the Productp. 7

   WARNING • Do not disassemble, repair or modify the product at your own discretion. -- Fire or electric shock accident can occur. -- Contact the service center…

6. ASSEMBLY and PREPARATIONp. 9

   CAUTION • Always use genuine components to ensure safety and product performance. • The product warranty will not cover damage or injury caused by the use of…

7. Mounting Holesp. 10

   Use M3 screws to mount the monitor. The holes for the screws are on the rear of the product. < Front of the product > < Rear of the product > CAUTION • This…

8. Portrait Layoutp. 11

   To install in portrait mode, rotate the set clockwise 90 degrees when looking at from the front. The portrait mode is only available on the scaler board. (The…

9. Storage Method for Panel Protectionp. 12

   Correct Method Cushion Panel When laying the product on a flat floor, pit it face down on a cushion or blanket to prevent scratching and damage. Panel If there…

10. Product installationp. 14

    Installing an LVDS Cable The LVDS cable port is located as shown in the figure below. When installing the product, make sure there is enough space to install…

11. Installing an LVDS Cablep. 14

    The LVDS cable port is located as shown in the figure below. When installing the product, make sure there is enough space to install the LVDS cable. 45 mm 30…

12. Lighting Installationp. 15

    This product must be installed with backlighting. Lighting must be installed behind the product so that the display can be seen clearly. Lighting 600 lux or…

13. Installation in Enclosurep. 16

    Install the product in the enclosure. Wear work gloves when installing the product. Do not use bare hands. Otherwise, it may cause personal injury. 1 Place the…

14. Precautionp. 18

    Correct Method Do not hold the screen area when holding the product. Use a soft cloth moistened with n-hexane to remove dust or stains on the screen. CAUTION •…

15. TROUBLESHOOTINGp. 20

    After-image appears on the product. Problem Action After-image appears when the product is turned off. • If you use a fixed image for a long time, the pixels…

16. PRODUCT SPECIFICATIONSp. 21

    The product specifications below may be changed without prior notice due to upgrade of product functions. Active Screen Size 80 cm diagonal Dimensions (Width x…

17. LVDS Pin Map Guidep. 23

    LCD Connector (CN1) : FI-RE51S-HF or Equivalent, refer to below table. • Mating Connector : FI-RE51HL • Cable length: 1 m of coaxial cable or less Pin No.…