BenQ PT20 (5A.JJR26.30E) user manual

Contents

1. About Dummy Penp. 4

   When replacing the pen nib on the dummy pen, take it from the dummy pen

2. Product Overviewp. 4

   About Touch Module Green LED: normal; orange LED: abnormal. Right View For better touch performance, keep the pen nib clean. When replacing the pen nib, take…

3. About Touch Modulep. 4

   Green LED: normal; orange LED: abnormal. Right View For better touch performance, keep the pen nib clean. When replacing the pen nib, take it from the dummy…

4. Dimensionsp. 5

   198.9 mm 69.6 mm 42.1 mm

5. Preparation for Setupp. 6

   Preparation for Setup

6. Environment Conditionp. 6

   The touch module functions with an PointWrite interactive projector for scalable finger touch functionality, transforming any flat surface into a virtual…

7. Surface Conditionp. 7

   Optimal finger touch quality is dependent on the selected surface condition. You can attach the touch module on a wall surface or existing board. It is…

8. Projector Requirementsp. 10

   The PointWrite touch module is only available for BenQ PointWrite series interactive projector. Make sure the PointWrite camera module is installed properly…

9. Touch Module Installationp. 11

   Screen Tolerance The ambient light or direct sun light may impact the screen size of touch area or cause interference. In this case, make screen size smaller…

10. Driver Installationp. 13

    When you are the first time to use this PointWrite Module, please install setup driver for Configuration setting. 1. Please go to below BenQ Display Website to…

11. Connectionp. 14

    Connecting the PointWrite to PC Use the USB cable1 to connect the PointWrite to PC. Plug the USB mini-B end into the projector and plug the USB type-A end into…

12. Configuration Settingp. 16

    Configuration Setting 1. PointWrite Mode: • Pen Mode: Default selection • Finger Touch Mode: Only available when PointWrite Module works with BenQ PointWrite…

13. Alignment Instructionsp. 17

    Alignment Instructions

14. Alignment Viewp. 17

    The PointWrite Alignment function is to set the orientation of the PointWrite to the screen. Alignment View: When clicking on the "Alignment View", the screen…

15. Adjustment for Touch Module Laser Curtainp. 18

    The laser curtain is a perfect plane to cover the screen in max fan angle of 180 degrees. The laser curtain is required to be parallel to the surface with the…

16. PointWrite Calibrationp. 21

    PointWrite provides two kinds of calibration methods: auto calibration and manual calibration. Auto calibration: Click on and the calibration process will run…

17. Specificationsp. 22

    Specifications Dual screen requires another dual screen driver, which can be download on product web page. Touch module Model Name PT20 Operating Voltage 4.8 ~…