HP Latex 64 Plus Cutting Solution (9TL91A) user manual

Contents

1. Introductionp. 5

   Welcome to your cutter • Cutter models • Documentation • Safety precautions • Main cutter components • Turn the cutter on and off • Connect the cutter to a…

2. Useful linksp. 14

   Visit the HP Latex Knowledge Center at http://www.hp.com/communities/HPLatex, where you can find detailed information about our HP Latex products and…

3. Load the substratep. 16

   IMPORTANT: You are strongly recommended to load the substrate before preparing the job on the computer. The loading process is the same, whether the job is a…

4. Cut the substratep. 27

   Introduction Contour cutting is made possible by the highly accurate Optical POSitioning system (OPOS). The OPOS sensor, which is mounted underneath the tool…

5. Detailed operation of the cutterp. 36

   Introduction This chapter contains a detailed list of all parameters that can be changed and tests that can be initiated from the cutter’s front panel. The…

6. Maintenancep. 47

   Clean cutter surfaces The cutter has a number of sliding surfaces, made of smooth metals and plastics. They are virtually friction-free and require no…

7. Troubleshootingp. 53

   Cutting quality is not satisfactory 1. Perform the confidence test, and check whether quality issues are also visible in this internal test. If not, perhaps…

8. Accessoriesp. 55

   There are two alternative ways to order supplies or accessories: • Visit http://www.hp.com/ on the Web. There you will also see the latest list of supplies and…

9. Specificationsp. 57

   Cutter dimensions HP 54 Basic Cutter HP Latex 54 Cutter HP Latex 64 Cutter Height 1145 mm (45.1 in) 1145 mm (45.1 in) Width 1750 mm (68.9 in) 1980 mm (77.9 in)…