Loading manual…
Loading manual…
WARNING! Electric Shock Hazard Failure to follow this advice may result in electrical shock or death. • Read and follow the safety and warnings outlined in…
F Spanner F Hex driver 8mm bit F M4 hex key F Powered driver F Flathead screwdriver F Cross-head screwdriver F Hand truck F Cutter F T20 star-head screwdriver…
For full product, cabinetry and service specifications, refer to the Planning Guide. To access the Planning Guide, scan the QR code or visit…
1. Measure cavity dimensions. Ensure minimum specifications have been met and clearances have been considered. 2. Ensure floor is level and clear and a…
1. Cut the straps and the line printed on the top of the carton. Lift to remove. Set cardboard aside for later use. 2. Remove the trim kit from the back of the…
French Door Model: Top trim 1. Loosen the left or right plug using a flathead screwdriver. French Door Model: Top trim 2. Push the top trim towards the…
1. Take care when moving the appliance. Tape the door shut to prevent it opening. 2. Remove the brackets from the non-hinge side of the pallet. 3. Tilt the…
1. Ensure wall stud or solid surface is present. 2. Measure the height from the floor to the front overhang and mark on the rear wall. The installation height…
1. Remove the M8 nut and washer from the M8 screw at the top of each door using the supplied hex key and spanner. 2. Remove the hanging bracket from and set…
1. On the side that will connect to the adjacent product, remove the flange bolts. 2. Add the flange joiners and reinsert the bolt. Tighten using a 3mm Allen…
1. To limit the door opening to 90⁰, lower the hinge limiting pin into the upper and lower hinges. 2. Refrigerator-Freezer models: Remove hinge cover plate.…
1. Connect one end of a braided hose to the tap. Flush water through hose prior to connection to remove any debris. 2. Push the hose through the plinth from…