Fisher & Paykel DD60SCX9 installation instructions

Contents

1. Components requiredp. 3

   TOOLS PARTS Not supplied F Box cutter F Crosshead screwdriver F Flat blade screw driver F Drill F 1x 13mm Drill bit F 1x 2.5mm Drill bit F Level F Pliers F…

2. Accessing your product specificationsp. 4

   A B D For full product, cabinetry and service specifications, refer to the Planning Guide. To access the Planning Guide, scan the QR code or visit…

3. Prior to installationp. 7

   1. Refer to the Planning Guide for cabinetry, cavity and service specifications. fisherpaykel.com/specify 2. Ensure the cabinet meets the minimum cavity…

4. Unpack all productsp. 10

   1. Remove the plastic wrap. 2. Remove the top packaging. Leave the base on to protect the floor surface while moving the dishwasher.

5. Apply sealing tapep. 12

   1. Ensure underside of countertop is clean and free of dust. 2. Remove backing from tape 3. Apply tape to top edge of cabinet ensuring it is centred and set…

6. Dishwasher securing optionsp. 13

   1. Securing through chassis sides: Screws must be fixed through the chassis sides and into the cabinet sides or packers. The dishwasher must be secured to stay…

7. Attach bracketsp. 14

   The brackets must lie flat on the chassis with the locking tabs facing out. The locking tabs must be properly inserted through the slots to secure the…

8. Attach Spacersp. 15

   1. Snap off the four spacers with an adhesive strip. 2. Place spacers on each side of the dishwasher between the brackets. 3. If required a larger spacer…

9. Push inside cavityp. 16

   1. Place hoses and cords through the service holes and into the adjacent cavity. 2. Carefully push the dishwasher into the cavity, feeding the hoses through…

10. Secure through chassis slotp. 17

    1. Pull the drawer halfway out to remove the tub. On each side of the tub, push locking tabs back. 2. Place the drawer on a protected surface to the left of…

11. Secure through chassisp. 20
12. Secure using bracketsp. 23

    1. If using brackets, partially open the top drawer. Lift the rubber seal and remove the left and right screw covers from the trim. 2. Fix side brackets using…

13. drain connection optionsp. 24

    Water softener models: Water pressure: maximum 1 MPa (145 psi), min. 0.1 MPa (14.5 psi). Non-water softener models: Water pressure: maximum 1 MPa (145 psi)…

14. Install drainp. 25

    1. Install the drain hose support as close to the countertop as possible, with a minimum distance of 750mm from the floor Thread the hose though the support.…

15. Connect water inletp. 27

    1. Check that the supplied rubber washer is inserted into the coupling. Do not turn water supply on before power has been connected. The dishwasher must be…

16. Connect Powerp. 28

    1. Connect power. 2. Check the water connections. Turn on the water supply and check for leaks. The dishwasher must be powered on for flood protection to be…

17. Installer checklistp. 29

    Installation F If power is disconnected, ensure water supply is turned off to prevent flooding. F Check all parts are installed correctly and are secure. F…

Other documents for this model

• Fisher & Paykel CONTEMPORARY (DD60SAW9) installation instructions
• Fisher & Paykel DD60DAW9 user manual