Loading manual…
Fisher & Paykel BGRV2 installation instructions
Open PDFOpens the file on fisherpaykel.com.
Contents
- Safety and warningsp. 2
! WARNING! If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. Do not…
- Parts supplied for installationp. 5
- Product dimensions – 30" modelsp. 6
- Product dimensions – 36" modelsp. 7
- Product dimensions – 48" modelsp. 8
- Clearance dimensions – gas and combination cooktop modelsp. 9
electrical and gas F A C C B G D * Guidance dimension only. Combustible covering for a ventilation hood and non-combustible surface clearances are governed by…
- Clearance dimensions – full induction cooktop modelsp. 10
electrical F A C C B G D * Guidance dimension only. Combustible covering for a ventilation hood and non-combustible surface clearances are governed by local…
- Backguard considerationsp. 11
z Installations against non-combustible surfaces: you may install the range without a backguard or choose any of the three backguards. z Installations close to…
- Ventilation requirementsp. 12
- Unpacking the rangep. 13
1 2 3 1 2 2 Remove both screws to detach the toe kick from the range. Open the door completely and open the hinge locks fully on both sides. Refer to page 13…
- Removing and refitting the oven door(s)p. 14
IMPORTANT! z Take care, the oven door is heavy. z Do not lift the oven door by its handle. Doing so may damage the door. z Ensure the oven and the door are…
- Location of electrical and gas supplyp. 15
A A B electricity and gas A A B electricity C C regulator* Final position of range against wall Final position of range against wall RDV3 & RHV3 MODELS RIV3…
- Electrical connectionp. 16
Wiring diagrams are also in the service summary, attached to the inside of the toe kick panel The rating label is located under the control panel A wiring…
- Gas connectionp. 18
1/2" NPT Minimum 5/8" dia. flex line. Supply Pressure: 6" to 9" W.C. LP gas z Connection: 1/2" NPT Minimum 5/8" dia. flex line. Supply Pressure: 11" to 14"…
- Toe kick installationp. 19
- Levelling the rangep. 19
- Cooktop burnersp. 20
LEAK TESTING z To check that the ignition system operates correctly, light each burner by itself, then all burners in combination. z Check for a well-defined…
- Leak testingp. 20
z To check that the ignition system operates correctly, light each burner by itself, then all burners in combination. z Check for a well-defined blue flame…
- Installing the anti-tip bracketp. 21
Once installed Check for proper installation of the range and Anti-tip bracket by grasping the back of the range and carefully attempting to tilt it forward.…
- Final checklistp. 22
TO BE COMPLETED BY THE INSTALLER GENERAL F Placement of unit. F Specified clearance maintained to cabinet surfaces. F Unit level – front to back, side to side.…