Garmin Fusion Handheld Microphone installation instructions

Contents

1. Important Safety Informationp. 1

   WARNING Failure to follow these warnings and cautions could result in personal injury, damage to the vessel, or poor product performance. See the Important…

2. Tools Neededp. 1

   Pencil • Drill • 16 mm (5/8 in.) drill bit • 2.5 mm (3/32 in.) drill bit • 16 mm (5/8 in.) socket or wrench • Phillips screwdriver • Marine sealant (optional)…

3. Connection Diagramp. 2

   Microphone connector You can securely mount the microphone connector in an accessible location (Installing the Connector Mount, page 4). RCA connectors You…

4. Specificationsp. 3

   Microphone dimensions (H×W×D) 88 × 60 × 34 mm (31/2 × 23/8 × × 111/32 in.) Power and audio cable length 60 cm (23 5/8 in.) Frequency response From 100 Hz to 4…

5. Installing the Connector Mountp. 4

   Before drilling a hole to mount the connector, you should verify that the microphone cable is long enough to reach the back of the stereo and the connector…

6. Mounting the Microphone Hangerp. 5

   NOTICE If you are mounting the bracket on fiberglass with screws, it is recommended to use a countersink bit to drill a clearance counterbore through only the…

7. Connection Diagramp. 6
8. Operating the Handheld Microphonep. 7

   You must configure the stereo before you can operate the handheld microphone (

9. Configuring the Fusion Stereo for the Handheld Microphonep. 7

   , page 7). You can use the handheld microphone from any source on the stereo. If the source is set to anything other than AUX1 when you hold the microphone…

10. Adjusting the Gain of the Handheld Microphonep. 7

    If the volume of the microphone broadcast is too loud or too quiet in relation to the other sources on the stereo, you can adjust the gain level for the AUX1…

11. Specificationsp. 8