Denon ZONE2 user manual

Contents

1. ENGLISHp. 4
2. Before Usingp. 5

   Pay attention to the following before using this unit: • Moving the set To prevent short circuits or damaged wires in the connection cords, always unplug the…

3. Cautions on Installationp. 5

   Noise or disturbance of the picture may be generated if this unit or any other electronic equipment using microprocessors is used near a tuner or TV. If this…

4. Cautions on Handlingp. 5

   Switching the input function when input jacks are not connected A clicking noise may be produced if the input function is switched when nothing is connected to…

5. Featuresp. 6

   1. Dolby Digital Using advanced digital processing algorithms, Dolby Digital provides up to 5.1 channels of wide-range, high fidelity surround sound. Dolby…

6. Connectionsp. 7

   Do not plug in the AC cord until all connections have been completed. • Be sure to connect the left and right channels properly (left with left, right with…

7. Part Names and Functionsp. 16
8. Using the Remote Control Unitp. 18

   Following the procedure outlined below, insert the batteries before using the remote control unit. Range of operation of the remote control unit Inserting the…

9. Setting up the Systemp. 19

   Once all connections with other AV components have been completed as described in “CONNECTIONS” (see pages 7 to 15), make the various settings described below…

10. Remote Control Unitp. 31

    NOTE: • TUNER can be operated when the switch is at “AUDIO” position. 31 ENGLISH

11. Operationp. 36

    Before operating 2 1 3 2 3 Preparations: Check that all connections are proper. 2 Turn on the power. Press the Power ON/STANDBY switch (button). ON / STANDBY 3…

12. Multi Zonep. 42

    Multi-zone playback with multi-source MULTI ZONE MUSIC ENTERTAINMENT SYSTEM • When the outputs of the “ZONE2” OUT terminals are wired and connected to…

13. Multi Zone Variable Volume Pre-amp Outputs pg. 43p. 43

    When using the SURR.BACK/ZONE2 amplifier as the ZONE2. • The SPEAKER OUT, LINE OUT and PRE OUT terminals can be used simultaneously in ZONE2. • To use the…

14. Surroundp. 45

    Before playing with the surround function • Before playing with the surround function, be sure to use the test tones to adjust the playback level from the…

15. DSP Surround Simulationp. 54

    This unit is equipped with a high performance DSP (Digital Signal Processor) which uses digital signal processing to synthetically recreate the sound field.…

16. Listening to the Radiop. 58

    Auto preset memory 1 When the main unit’s power operation switch turn on while pressing the set’s PRESET • (+) button the unit automatically begins searching…

17. Last Function Memoryp. 61

    This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched…

18. Initialization of the Microprocessorp. 61

    When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the…

19. Additional Informationp. 62

    Optimum surround sound for different sources There are currently various types of multi-channel signals (signals or formats with more than two channels). 2…

20. Troubleshootingp. 69

    If a problem should arise,first check the following. 1. Are the connections correct ? 2. Have you operated the receiver according to the Operating Instructions…

21. Specificationsp. 70
22. List of Preset Codesp. 71