Sharp PN-V601A user manual

Contents

1. Part Namesp. 3
2. Basic Operationp. 5

   When performing operation of multiple monitors with the remote control unit, first set the remote control unit to the appropriate remote control mode (see page…

3. Remote Control Modep. 7

   With the remote control unit it’s possible to perform operation of... • The primary monitor • Monitors with a specified ID No. • All primary/secondary monitors…

4. Menu Itemsp. 8

   Displaying the menu screen Video and audio adjustment and settings of various functions are enabled. This section describes how to use the menu items. See…

5. Displaying the menu screenp. 8

   Video and audio adjustment and settings of various functions are enabled. This section describes how to use the menu items. See pages 9 to 12 for details of…

6. Menu item detailsp. 9
7. Adjustments for PC screen displayp. 15

   nAutomatic adjustment When you use the PC D-sub input terminal or PC RGB input terminals to display a PC screen for the first time, or when you change the…

8. Initialization (Reset)/Functional Restriction Setting (FUNCTION)p. 16

   LED Specifies whether to light the power LED. OFF cannot be selected when STANDBY MODE is LOW POWER. TEMPERATURE ALERT Selects the notification method for an…

9. Controlling the Monitor with a PC (RS-232C)p. 17

   You can control this monitor from a PC via RS-232C (COM port) on the PC. You can also connect multiple monitors via a daisy chain by using a PC. By assigning…

10. PC connectionp. 17

    nOne-to-one connection with a PC Connect with RS-232 straight cable between the PC’s COM port (RS-232C connector) and the RS-232C input terminal on the…

11. Communication conditionsp. 17

    Set the RS-232C communication settings on the PC to match the monitor’s communication settings as follows: Baud rate * Stop bit 1 bit Data length 8 bits Flow…

12. Communication procedurep. 17

    nCommand format When a command is sent from the PC to the monitor, the monitor operates according to the received command and sends a response message to the…

13. Setting of the GAMMA user datap. 20

    nTo transfer the GAMMA user data Use the user data transfer commands (UGRW, UGGW and UGBW). For each of the R, G and B colors, divide the total 512 pieces of…

14. RS-232C command tablep. 21

    How to read the command table Command: Command field (See page 17.) Direction: W When the “Parameter” is set in the parameter field (see page 17), the command…

15. Controlling the Monitor with a PC (LAN)p. 28

    Settings to connect to a LAN Set the monitor’s IP address and subnet mask to match the settings of your LAN. These settings can be made on either the monitor…

16. Settings to connect to a LANp. 28

    ”. (See the description on the right.) • Your PC must be installed with Internet Explorer (version 6.0 or later). • To control the monitor via LAN, set…

17. Controlling with a PCp. 30

    Basic operation You use Internet Explorer on a PC on the LAN to control the monitor. 1. Launch Internet Explorer on the PC. 2. In the “Address” box, type…

18. Troubleshootingp. 36

    If you are experiencing any problem with your display, before calling for service, please review the following troubleshooting tips. There is no picture or…

19. Specificationsp. 37

    nPN-V601A Product Specifications Model PN-V601A LCD component 60" Class [60 inch (152.4cm) diagonal] TFT LCD Max. resolution (pixels) 1366 x 768 Max. colors…