BenQ LU960UST (9H.JMT77.25E) installation instructions

Contents

1. Noticep. 3

   on laser This symbol indicates that there is a potential hazard of eye exposure to laser radiation unless the instructions are closely followed. yy Laser class…

2. Notice on laserp. 3

   This symbol indicates that there is a potential hazard of eye exposure to laser radiation unless the instructions are closely followed. yy Laser class (for…

3. Cooling noticep. 4

   Allow at least 50 cm (19.7 inch) for clearance around the exhaust vent. Make sure no objects block air inlet within 50 cm (19.7 inch). Keep the outlet at least…

4. Product informationp. 6

   Packing content Remote Control Power Cord(s) Regulatory Statement

5. Specificationp. 6

   LU960UST Projection system 1-CHIP DMD Native resolution 1920*1200 pixels, 16:10 Light source Laser diodes Power consumption 500Watts (Normal mode)/ 380Watts…

6. Terminalsp. 7

   MINI-B Support Mini USB type B for service only. LAN For connection to RJ45 Cat5/Cat6 Ethernet cable to control the projector through a network. HDBaseT For…

7. Remote controlp. 8

   ON / OFF Toggles the projector between standby mode and on. KEYSTONE+/KEYSTONE- Manually corrects distorted images resulting from an angled projection. VOLUME…

8. Installationp. 10

   Projection table • LU960UST The screen aspect ratio is 16:10 and the projected picture is 16:10. Note: To optimize the projection quality, we suggest to…

9. Projection tablep. 10

   LU960UST The screen aspect ratio is 16:10 and the projected picture is 16:10. Note: To optimize the projection quality, we suggest to project images in an area…

10. LED indicatorp. 12

    yy LED Usage LED Name Detailed Description Power LED Display the power on/off sequence status Orange : Power Off (Green + Red) Green : Power On Blink : Warming…

11. Projector dimensionp. 15
12. RS232 command controlp. 16
13. RS232 pin assignmentp. 16
14. RS232 serial port with a crossover cablep. 16
15. PJLinkp. 24

    yy PJLink protocal The network function of this projector support the PJLink class 1, and the PJLink protocal can be used to perform projector setting and…