BenQ LU960ST (9H.JN577.25E) user manual

Contents

1. Noticep. 3

   on laser Caution – use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Do…

2. Notice on laserp. 3

   Caution – use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Do not…

3. Cooling noticep. 4

   Allow at least 50 cm (19.7 inch) for clearance around the exhaust vent. Make sure no objects block air inlet within 50 cm (19.7 inch). Keep the outlet at least…

4. Product informationp. 6
5. Specificationp. 6

   LU960ST LU960 Projection system 1-CHIP DMD Native resolution 1920*1200 pixels, 16:10 Light source Laser diodes Throw ratio 0.77 ~ 0.84 1.13 ~ 1.70 Power…

6. Terminalsp. 7

   MINI-B Support Mini USB type B for service only. LAN For connection to RJ45 Cat5/Cat6 Ethernet cable to control the projector through a network. HDBaseT For…

7. Remote controlp. 8

   ON / OFF Toggles the projector between standby mode and on. KEYSTONE+/KEYSTONE- Manually corrects distorted images resulting from an angled projection. VOLUME…

8. Installationp. 10

   Lens Cap / Lens Lock 1. Remove lens cap before booting. 2. Install lens lock 3. Secure with screws, do not fully tighten 4. Adjust the focus 5. Tighten the…

9. Lens Cap / Lens Lockp. 10

   1. Remove lens cap before booting. 2. Install lens lock 3. Secure with screws, do not fully tighten 4. Adjust the focus 5. Tighten the screws

10. Projection tablep. 11

    LU960ST The screen aspect ratio is 16:10 and the projected picture is 16:10. Note: To optimize the projection quality, we suggest to project images in an area…

11. LED indicatorp. 13

    yy LED Usage LED Name Detailed Description Power LED Display the power on/off sequence status Orange : Power Off (Green + Red) Green : Power On Blink : Warming…

12. Projector dimensionp. 16
13. RS232 command controlp. 17
14. RS232 pin assignmentp. 17
15. RS232 serial port with a crossover cablep. 17

    Function Type Operation ASCII Power Write Power On <CR>*pow=on#<CR> Write Power Off <CR>*pow=off#<CR> Read Power Status <CR>*pow=?#<CR> Source Selection Write…

16. PJLinkp. 24

    yy PJLink protocal The network function of this projector support the PJLink class 1, and the PJLink protocal can be used to perform projector setting and…